Use proper torque settings and ensure tools are sharp. Follow manufacturer guidelines for tightening standoffs.

F5F Stay Refreshed Hardware Desktop Use proper torque settings and ensure tools are sharp. Follow manufacturer guidelines for tightening standoffs.

BigCraike
Member

09-24-2016, 05:56 PM

I bought an inexpensive case with most standoffs already attached, but two are tough to fully secure. Scratching the black finish on a standoff isn’t ideal. To tighten them without a special tool, use a basic wrench or pliers carefully.

BigCraike

09-24-2016, 05:56 PM #1

Stromineur
Member

206

09-25-2016, 03:19 AM

A small tweak of the wrench should suffice. Be careful not to over-tighten it—this is just for appearance and stays concealed beneath the motherboard.

Stromineur

09-25-2016, 03:19 AM #2

A small tweak of the wrench should suffice. Be careful not to over-tighten it—this is just for appearance and stays concealed beneath the motherboard.

AtomDev
Junior Member

10-02-2016, 08:02 AM

The pliers should suffice. A light scratch on the surface is acceptable since the paint isn’t noticeable through the panel.

AtomDev

10-02-2016, 08:02 AM #3

The pliers should suffice. A light scratch on the surface is acceptable since the paint isn’t noticeable through the panel.

Tralalapoo
Junior Member

10-04-2016, 06:40 PM

You can secure them manually or employ a suitable size hex bit/tool. Just ensure they are hand-tightened; no need to apply torque.

Tralalapoo

10-04-2016, 06:40 PM #4

You can secure them manually or employ a suitable size hex bit/tool. Just ensure they are hand-tightened; no need to apply torque.

PersieO
Posting Freak

786

10-04-2016, 08:18 PM

Typically, most of what I encounter has a hex cap designed to cover the standoffs, featuring a Phillips head machined into the top, allowing you to tighten it using a regular screwdriver. Look inside the accessories baggies?