Uncomfortable setup of the IO shield, not my doing.
Uncomfortable setup of the IO shield, not my doing.
Hey guys. You notice something strange with this IO shield installed? Looks kinda bulky and if you can notice there is a lot of flex towards me. The top buttons look kinda stuck and should be more sticking outwards. I really don't know what happened,since I hada lot of problems installing this IO shield so I took pc case and board to local pc service and then this ..
It works well due to flexible components that keep it firmly attached to the motherboard and prevent buttons from sticking. It seems unlikely to be removable—it's built-in during manufacturing. In the video, it's tough to see clearly, but I believe there are two layers: a plastic outer shell that feels flexible, and a denser metal layer underneath.
Yes, that's typical. The IO shield has slight flex, especially outward, which is normal.
If the design is older, I’d say the I/O shield and motherboard are properly fitted, though they might have been a bit closer to the shield with the screw mounts. It doesn’t really matter. I’d call it “within spec” because an oil shield mainly keeps dust out and makes it easy to label port names. You can operate a PC without one at all.
As i said, i pretty sure that it's the plastic layer that flexes, well, just because it's plastic. See for yourself, there a most likely a layer of actual metallic sheet underneath.
And even if it’s not that way it’s still not important particularly. There’s a certain amount of slop in motherboard stand off holes.
Sure thing. If it's the vintage style, you'll need to purchase the item, then use a screwdriver to adjust the standoff by about three-quarters of a turn, secure the motherboard into the I/O shield more firmly, and tighten it again. For the newer version, there are no I/O shields—just plain, unremarkable components.