Unable to start DOCP Kingston FURY Beast RAM.
Unable to start DOCP Kingston FURY Beast RAM.
Hello! I recently purchased a Kingston FURY Beast DDR4 3200MHz CL16 32GB kit. After installation, the RAM functions properly at 2400Mhz. However, when I enable DOCP standard, the system fails to boot. My motherboard is an ASUS ROG STRIX B450-F GAMING, and this RAM model appears on their supported list. I'm unsure what might be causing the issue. I've tried several steps: switching to DOCP Standard, keeping the Overclock Tuner on Auto (only changing Frequency Mode to DDR4-3200), updating the BIOS, and contacting both ASUS and Kingston. I've only adjusted one stick at a time. Any advice would be greatly appreciated!
Have you attempted adjusting the voltage and timing manually according to the sticker on the modules? That would be my initial attempt; if it fails, try 2993MT/s and continue lowering the RAM clock speed until it functions. What processor are you using? Since this is more critical now than the boards themselves.
You recently attempted to adjust the voltage and timing settings, but those changes didn't take effect. Now you're experiencing issues booting with the old stick settings that previously worked. You're currently holding off to reset the BIOS using the CMOS battery, hoping it will restore functionality.