Two routers connected with a single cable.
Two routers connected with a single cable.
Hey, I’m struggling with this setup. I have two routers—one on 2.4 GHz and another on 5 GHz—and they’re linked together. My PC uses a cable connection, so it’s not sure how to switch between them. The Steam link isn’t working because the PC is tied to the main router. Anyone know how to fix this?
Usually two routers clash, it’s unusual you’re getting any results. What makes your configuration so strange?
I own a large home so I require more than one device, but the main router is only for internet access, which isn’t enough to justify spending a lot on a faster model. I’m wondering if they can work together, since it seems like the Wi-Fi and Steam Link should connect seamlessly.
Check the router models and verify internal connections via software. Ensure firewall rules, DMZ setup, and port forwarding are properly configured.
The 5GHz model is a Cisco WAP131, while the main router uses a Fritz Box with a WLAN 7360. I’m not sure about the connection method or the software involved.
I’d choose one of two options. You can skip the 2.4ghz router and use only the 5ghz model. If you need both, pick a primary router and opt for the faster one. For the second router, turn off DHCP and disable the firewall. Configure your Wi-Fi settings as desired, then connect your first router through its LAN port to the LAN port on the second router via LAN. This setup will make the second router function like a switch with Wi-Fi features, helping fix connectivity problems.
It seems a bit confusing, but the primary router already has the fiber link. So where would the second router connect then? If the main router is handling the connection, the second router would likely need to link through another device or switch.
Your primary router functions more like a gateway than a simple router. It combines modem and router capabilities, right? If the first router is also your modem, you won’t be able to interchange them. But the overall steps remain consistent. The setup would follow Fiber → Router 1 (gateway) → Router 1 LAN port to Router 2 LAN port.
The WAP131 functions as an access point but includes a built-in DHCP server. This might be the cause of the problem. Navigate to the WAP131, confirm it's operating in access point mode, then locate the DHCP server setting and disable it. This will route all traffic through your primary router, effectively making it an extension of the main device. Currently, DHCP appears active, so connections on the WAP131 are likely on a separate network from the Fritz router, preventing communication. You can test this by checking your IP address on each device. If the first three octets differ (for example, 192.168.0.xxx vs 192.168.1.xxx), they each have DHCP enabled and you should avoid that scenario—only the Fritz router should have it active. If you struggle to locate these settings, share a screenshot of the webpage. Be sure to remove any identifying details such as your WAN IP address.