Trident Z RGB 3000 kit OC'ing

muffles45
Member

189

11-05-2016, 01:28 PM

I'm wondering if perhaps I'm doing it incorrectly.
I've checked various preset DDR4 RAM kits and experimented with different frequencies and CAS timings, ranging from tight to loose settings.
I'm struggling to reach more than 3200mhz while staying within the 100:133 ratio range.
Is there a specific setting I'm missing? I'm hoping for some guidance that could help. Maybe it's related to command rate timing? I've left it on auto, and I'm not using BCLK overclocking. Would enabling BCLK overclocking help me surpass the 3200mhz 100:100 barrier?
I know the RAM might have limitations, but I think at least one adjustment could get us closer to the 3866 maximum supported speed listed on my board.

muffles45

11-05-2016, 01:28 PM #1

farazofbuscus
Member

212

11-06-2016, 01:12 PM

You can't find 3200-rated modules close to 3866.

farazofbuscus

11-06-2016, 01:12 PM #2

You can't find 3200-rated modules close to 3866.

Goku_Jerome
Senior Member

428

11-06-2016, 03:05 PM

You can't find 3200-rated modules close to 3866.

Goku_Jerome

11-06-2016, 03:05 PM #3

You can't find 3200-rated modules close to 3866.

XmaloX
Junior Member

11-16-2016, 10:49 AM

I think it's related to binning. I've seen the 100:133 (over 3200) zone costs more than a 100:100 ratio (3200 or less). It wasn't even able to run past 3200. As expected, you get what you pay for.

XmaloX

11-16-2016, 10:49 AM #4

I think it's related to binning. I've seen the 100:133 (over 3200) zone costs more than a 100:100 ratio (3200 or less). It wasn't even able to run past 3200. As expected, you get what you pay for.