The USB 3.0 header is damaged in an unusual manner, not the typical break.
The USB 3.0 header is damaged in an unusual manner, not the typical break.
I switched my case. After taking out the USB 3.0 cable from my motherboard, the little plastic holder came along with it. I verified twice that there are no bent or broken pins. Is there a secure method to reattach the plastic component? Can I simply use glue and reinsert it? Thank you ahead of time. P.S. I’m really sorry for all the English speakers who struggle with my language—please forgive me.
If only the plastic casing detached, I’d apply a small amount of super glue. That kind dries quickly—just add a few drops to a piece of plastic and use a toothpick to spread it onto the base. Once it’s set, press the housing back in place and hold it for a moment. Avoid moving it while it cures; this is usually the biggest issue. If it loosens again, it’s hard to reattach properly afterward. Wait until it’s fully cured before handling. Don’t apply glue directly to the casing and then force it on—it can create a mess that’s tough to clean.
No adhesive needed. Just position the pins, move the plastic cover, and lower it. Avoid using certain glues as they may damage the circuit board.