The motherboard doesn't have a header for your case fans.

KaWizK
Member

07-03-2025, 08:22 PM

Hello to anyone reading this. I'm starting my first computer build and encountered a problem while connecting my cables. I'm using the Antec NX410 case and ASRock Z790M PG Lightning/D4. While plugging in, I noticed the case fans didn't have a slot for the cable. I searched online but found nothing. I've attached a photo of the wire, and anyone with advice would be greatly appreciated. Also, I have a SATA cable, and I'm curious about its connection point.

KaWizK

07-03-2025, 08:22 PM #1

jaffercake59
Member

163

07-03-2025, 11:57 PM

I haven't reviewed that document. Would you like me to summarize its contents or help with anything else?

jaffercake59

07-03-2025, 11:57 PM #2

I haven't reviewed that document. Would you like me to summarize its contents or help with anything else?

gummy246
Junior Member

07-04-2025, 07:16 AM

They link to an RGB controller in the setup, which then connects to your board. Refer to the manual for details.

gummy246

07-04-2025, 07:16 AM #3

They link to an RGB controller in the setup, which then connects to your board. Refer to the manual for details.

grimwolf1
Junior Member

07-04-2025, 12:30 PM

I reviewed the instructions, though it wasn’t included with the fan manual. Now I grasp most of it, but I’m unsure about the location of the RESET SW wire (B in Figure 1).

grimwolf1

07-04-2025, 12:30 PM #4

I reviewed the instructions, though it wasn’t included with the fan manual. Now I grasp most of it, but I’m unsure about the location of the RESET SW wire (B in Figure 1).

Devon_playz
Member

131

07-05-2025, 12:19 AM

whoops

Devon_playz

07-05-2025, 12:19 AM #5

whoops

ItzFireMLG
Member

215

07-08-2025, 12:19 AM

The "Reset SW" needs to be connected to the LED button at the top of the case. A dedicated cable or header must be used for this connection. Antec provided clear guidance on wiring the fans.

ItzFireMLG

07-08-2025, 12:19 AM #6

The "Reset SW" needs to be connected to the LED button at the top of the case. A dedicated cable or header must be used for this connection. Antec provided clear guidance on wiring the fans.

Devies
Member

185

07-08-2025, 02:11 AM

I understand the connection points, but I couldn't locate the correct port for insertion. All the connectors on my board differ from yours, and I've tested various ones without success.

Devies

07-08-2025, 02:11 AM #7

I understand the connection points, but I couldn't locate the correct port for insertion. All the connectors on my board differ from yours, and I've tested various ones without success.

_MrJunior
Junior Member

07-08-2025, 10:20 PM

The device isn’t linked to the motherboard’s ports. According to Antec’s guide, it should be attached via case ports/headers or the fan/RGB controller included. Their instructions aren’t reliable, so I can’t pinpoint the exact header location without seeing the physical unit.

_MrJunior

07-08-2025, 10:20 PM #8