The I5 7600k with a 4.7ghz clock speed and 1.3s sound is suitable for your needs.
The I5 7600k with a 4.7ghz clock speed and 1.3s sound is suitable for your needs.
Hi everyone,
I'm new to this and just wanted to check your settings.
I overclocked my i5 7600k to 4.7ghz on an asus z270g strix motherboard. The voltage is set manually, but I tried 1.275 and 1.3 vcore. Both seem fine, so I ended up with 1.3.
Does that sound correct? Or could it be too high or too low? The temperatures look okay and everything runs well. I haven't done a proper bench beyond the cpuz test yet.
Are there any risks with using a lower vcore than ideal? Any advice would be great!
Thanks.
Aiming for high frequency with minimal voltage is ideal for better performance. However, 1.3V at 4.7Ghz can be challenging. If thermal issues are manageable, it may not be a major concern, but it increases power consumption and heat generation. You typically balance by either boosting frequency for peak performance or reducing voltage to extend CPU lifespan and lower temperature/noise. Instability or test failures usually indicate the voltage is too low for the target frequency, forcing a choice between raising voltage or lowering frequency.
Aiming for high frequency with minimal voltage is ideal for better performance. However, 1.3V at 4.7Ghz can be challenging. If thermal issues are manageable, it may not be critical, but it increases power consumption and heat generation. Usually, you balance by either boosting frequency for peak performance or reducing voltage to extend CPU lifespan and lower temperature/noise. Instability or test failures usually indicate the voltage is too low for the target frequency, forcing a choice between raising voltage or lowering frequency.
You aim for high-frequency operation while minimizing voltage usage for better efficiency. Lowering the voltage reduces power consumption and heat generation, but it also impacts performance. If stability issues arise or tests fail, it indicates the voltage may be too low for your frequency, requiring a trade-off between raising voltage or reducing frequency. Your original settings of 1.275 to 1.280 might still be suitable if they performed adequately at that point.