The eGPU lacks sufficient 8-pin connections. Consider alternative solutions or check compatibility.
The eGPU lacks sufficient 8-pin connections. Consider alternative solutions or check compatibility.
You have the right setup with two 8-pin PCIe ports on your EVGA 3080 and two 8-pin ports on your Razer Core X. The issue is matching the number of inputs to the number of outputs. Since the 3080 needs three 8-pin inputs, you’ll need to configure it to use only two of its ports. You can do this by setting the 3080 to operate with two of its PCIe slots, possibly using a BIOS setting or driver configuration. This won’t require replacing hardware but will adjust how the GPU uses its ports. If you’re unsure, check your motherboard manual or contact EVGA support for guidance. TLDR: Yes, you can adapt it with two ports instead of three.
Several studies highlight forum discussions about using the enclosure with a splitter, though I wouldn't recommend it myself—yet it appears to work well for others. https://egpu.io/forums/which-gear-should...ng-x-trio/ If I had to choose, I'd probably opt for a fresh power supply.
The power supply in this case is very poor. It has several 12v rails but lacks multiple OCP, uses goup regulation and has bad voltage control. Avoid using it with a powerful GPU. For an RTX 3080, you should get a new good PSU with DC-DC on the smaller rails.
I’m choosing a SF750 and some 3D printable brackets to resolve this issue. https://www.printables.com/model/309699-...kets/files Most people agree to use a SFF PSU and secure it with 3D printed supports or tape. Thanks for any tips!