The DRAM QLED feature appears to be linked to the RAM stick's configuration. It may also stem from a BIOS issue.
The DRAM QLED feature appears to be linked to the RAM stick's configuration. It may also stem from a BIOS issue.
Hello everyone, I just installed a new computer and placed the two RAM sticks in the primary slots A2/B2. When I power it on, the yellow LED lights up but the system halts from booting. After checking the QVL List, I confirmed my RAM sticks are listed, though the version shown differs from what appears on the site (I’m using version 5.33.01). Does the RAM version matter? I’ve seen others suggest updating the BIOS, but I don’t have a display yet. I attempted a BIOS flash using a YouTube tutorial and a properly formatted USB drive, but the issue persists. The small light stopped flashing after holding a button briefly. The tutorial even worked before the CPU was built, so maybe I made a mistake—I’m worried I might have bricked my motherboard. Could a lower BIOS version fix this? Or are there other steps I should try regarding the BIOS update? Thanks ahead for your help!
Specs: Intel Core i9-14900KF 3.2 GHz, 24-core processor, Asus ROG STRIX B760-A, gaming Wi-Fi ATX LGA1700, Corsair Vengeance, 32 GB DDR5-5600 CL36 memory (CMK32GX5M2B5600C36), Crucial P5 Plus 2 TB M.2-2280 PCIe 4.0 X4 NVMe SSD, Gigabyte WINDFORCE OC graphics card, 12 GB video card. Attached file says “compatible memory stick” per ASUS.
Check the rear of your motherboard and locate the button plus the USB port for updating BIOS. Obtain the newest BIOS file and insert the USB drive. Place it into the designated slot for BIOS flashing on your motherboard and press the corresponding button. No screen needed. For additional details, try a quick YouTube search or visit your motherboard’s website. Success is within reach.
It's tricky to figure out exactly what's going on. You might need more info if you'd like, but the main point is compatibility matters. The latest version of your kit likely has better BIOS support than the older 4.43.02 model. I'd start by checking if everything is seated properly, then swap in each component one at a time. If you suspect a faulty board, the LED near the CPU might indicate the issue isn't there. It seems the update probably fixed the problem.
I attempted again but the light remains on, leading me to think it's permanently damaged. At this stage I had no clear direction, so I waited a short time and then removed the drive when nothing occurred. If that wasn't the right step, it still passes through the CPU light during startup, suggesting the issue might be elsewhere. If I could verify it isn't completely bricked, I should keep going and reinsert the CPU and storage.