The Amd fx pile driver 6300 works with the MSI 970A-G43.
The Amd fx pile driver 6300 works with the MSI 970A-G43.
Hi everyone
I'm using an MSi 970A-G43 with a FX piledriver 6300 CPU, watercooled via Corsair H60. I'm wondering if you could assist me with safe overclocking settings and the process. I'm on furlough and can't afford to upgrade right now. Thanks in advance!
Further hardware
- Ram: 32gb
- GTX: 1060 graphics card
- dave
Not focusing on CPU cooling, you're all right. The issue is with the VRM on the motherboard, which would struggle to supply sufficient power for a higher CPU without overheating. Switching to a water cooler instead of a standard air cooler that blows air on the VRM only makes things worse.
Sorry, I don't have much knowledge on this topic. I assumed watercooling would be superior to heat sink-based coolers, but I might have been influenced by marketing. I've done some research and now I think my motherboard isn't doing well.
Not focusing on CPU cooling, you're all right. The issue is with the VRM on the motherboard, which would struggle to supply sufficient power for a higher CPU without overheating. Switching to a water cooler instead of a standard air cooler that blows air on the VRM only makes things worse.
I appreciate your guidance. Could you point me toward a guide on how to safely increase its overclocking potential?
OC is quite accommodating for those processors. Just unlock them and adjust the multiplier slightly while checking stability and temperature. If everything stays within bounds and it works, increase the notch incrementally until instability appears, then add a bit more voltage until the temperature climbs too much. I can't provide exact numbers since each setup is unique. Keep an eye on VRM heat, as CPUs handle heat well but require significant power, which can cause the VRM to overheat.