The access point isn't functioning with both wired and wireless connections.
The access point isn't functioning with both wired and wireless connections.
Hi Zac, you're facing a common setup challenge. It sounds like the NETGEAR Access Point might be handling traffic differently depending on whether it's connected to a wireless device or an Ethernet port. Sometimes the router switches between modes, which can cause the two types of connections to behave oppositely. Have you checked if the Access Point is properly configured for both wired and wireless interfaces? Also, ensure all cables are securely connected and that your network settings match what the router expects. If you're still having trouble, sharing more details about your setup might help identify the issue. Let me know!
The AP's connection to the main router was confirmed. If it uses Ethernet, the port is likely connected to the WAN or LAN side of the AP—assuming it's a standard AP, I don't have the exact model number. Also, verify that the firmware is current; outdated versions can sometimes cause compatibility issues. Manufacturers often include hidden bugs in their software.
Is it operating in bridge mode? It connects to the main router's Wi-Fi and switches it to Ethernet. No Wi-Fi is needed since it's just facilitating a router-to-router link.
I haven’t installed the latest firmware yet. I’m currently using another router from NETGEAR, which isn’t working either. Updating the firmware hasn’t helped—it shows an error saying it failed to update. I’m using a hand crimped Ethernet cable to link my master and slave routers; could this be the problem?
adjusted the ethernet cable connections, choosing a crossover or matching setup. Also, remember that the second router will act as the gateway, while connected devices will use its IP address for easy access. The first router’s DHCP start address is set to 192.168.1.3 with a range from .10 to .32, and the second router assigns a static IP of 192.168.1.2, using a DHCP range of .34 to .65 so devices can auto-configure properly.
Instead of using Double NAT—which can create problems—consider configuring the second router as an access point. Assign it an internal IP like 192.168.1.2, adjusting it based on your main router’s address (add one). Disable DHCP entirely, connect only via LAN port, and leave the WAN port unused. This method works with any router that supports disabling DHCP, typically standard routers not bundled as modems. The key difference from a true AP is that an AP lacks WAN functionality and other advanced features like NAT or firewall, and it’s set up in this straightforward way by default.
Thank you for your responses. You reviewed the article at http://www.tested.com/tech/298-how-to-us...i-network/. It explains how to configure an Access Point as a wireless access point, though it won't handle data transmission via both wireless and wired methods simultaneously. I turned off DHCP on the second router, placed it outside the range of the first router, and ensured they shared the same gateway, subnet mask, SSID, and encryption settings. Typically, I connect the Ethernet cable carrying internet access into the first LAN port.