That's not right! I'm here to help you.

rebelzeina
Member

110

03-08-2019, 03:40 PM

Received a fresh 3600 unit and updated my profile info. My 1700 model ran smoothly at 3200MHz without issues. When using the 3600, the system freezes right after I try to exit bios, then stays unresponsive for about five minutes before restarting. It’s really annoying. I also attempted just entering bios while leaving with no changes and still got locked up. Changed default settings didn’t help either. No clear reason why my PC freezes after exiting bios even when nothing is altered.

rebelzeina

03-08-2019, 03:40 PM #1

xFqtal_
Senior Member

670

03-09-2019, 07:57 AM

I just installed this update, and my GPU reaches full speed every time I turn on or off the machine, which is really bothersome and wasn’t an issue before.

xFqtal_

03-09-2019, 07:57 AM #2

I just installed this update, and my GPU reaches full speed every time I turn on or off the machine, which is really bothersome and wasn’t an issue before.

OnlyYash
Junior Member

03-09-2019, 08:33 AM

Disconnect the power source, remove the battery from the motherboard, and keep the PC power button pressed for ten seconds. After that, reinsert the battery and restore power. Wait a moment before powering up; enter BIOS, apply default settings, adjust the clock, and attempt to boot.

OnlyYash

03-09-2019, 08:33 AM #3

SuperAaro
Junior Member

03-29-2019, 04:17 PM

It seems I can't connect to the battery because it's embedded in the cooler master H100, but I do have access to the jumpers.

SuperAaro

03-29-2019, 04:17 PM #4

It seems I can't connect to the battery because it's embedded in the cooler master H100, but I do have access to the jumpers.

TheBozoPlays
Senior Member

642

04-05-2019, 06:17 PM

Jumpers could work, yet certain aspects aren't reinitialized through the clear CMOS switch. In particular, RAM settings and PCIe arrangements remain affected.

TheBozoPlays

04-05-2019, 06:17 PM #5

Jumpers could work, yet certain aspects aren't reinitialized through the clear CMOS switch. In particular, RAM settings and PCIe arrangements remain affected.

brobear7
Posting Freak

892

04-06-2019, 09:38 PM

brobear7

04-06-2019, 09:38 PM #6

Boojazz
Member

145

04-10-2019, 08:39 AM

It used to work normally until after the POST completes. The issue arises only when it remains at full capacity once you enter BIOS or the operating system.

Boojazz

04-10-2019, 08:39 AM #7

It used to work normally until after the POST completes. The issue arises only when it remains at full capacity once you enter BIOS or the operating system.

LuckyHippo1
Member

04-10-2019, 09:42 AM

It sounds like your system is running at maximum fan speed, which can happen with certain motherboards or under heavy load. Double-check the BIOS settings or fan curve to ensure it's set correctly.

LuckyHippo1

04-10-2019, 09:42 AM #8

It sounds like your system is running at maximum fan speed, which can happen with certain motherboards or under heavy load. Double-check the BIOS settings or fan curve to ensure it's set correctly.