System starts up briefly before shutting down, then resumes functioning properly.
System starts up briefly before shutting down, then resumes functioning properly.
Thanks for the assistance. Please review the bios and get back to me, but I'll keep my PC in standby mode moving forward.
Also the stress from capacitors draining at night and then being recharged quickly puts a heavy demand on the power grid and the PSU. If possible, try to prevent this! (We're referring to capacitors that can sustain a PC for a few seconds even with hundreds of watts!)
Hello, thank you for reaching out once more. After disconnecting my PC from power, I haven’t seen any power cycling issues, so I’ll keep that in mind. There don’t seem to be any BIOS settings that could cause problems, which suggests the issue might have been elsewhere. Appreciate your help!
Hi there! I've faced the same challenge too. It began after I added an M.2 SSD and adjusted XMP SDRAM settings in BIOS on my Asus Maximus X Hero motherboard. Even when I turned off the power cable, the PC would briefly restart for a second before shutting down and then booting again. After some troubleshooting, I discovered a BIOS setting that was causing this issue: APM Configuration → ErP Ready → Enable (S4+S5). Once I turned it off (ErP Read → Disabled), the system would start normally without the 1-second shutdown. Hope this helps! P.S. Enabling fast boot in Windows Power Options didn’t resolve the problem.
Hey everyone! I've been facing the same issue recently. I've tried various solutions without success. Yesterday, I removed the RAM (quad channel) and switched to dual channel, which resolved the problem. However, when I reverted to quad channel, it started acting up again—booting, shutting down, then restarting normally after a few seconds. I suspect this might be related to Windows, especially since I've had issues after installing a new M2 with Windows. Could anyone help me figure this out?
I faced an issue with my Gigabyte Elite Z890 motherboard. It turned out the front power button wire was linked to the incorrect two-pin connector on the board. Follow the manual carefully and ensure the front power button connector matches the correct two-pin connector on the motherboard. If mismatched, your system might start but then stop during boot, and a B1 error code could appear.