F5F Stay Refreshed Hardware Desktop System fails to start upon connecting the device.

System fails to start upon connecting the device.

System fails to start upon connecting the device.

W
WOGGIGAME8
Member
Find
60
03-26-2016, 06:36 AM
#1
Hello. Perhaps the community might offer some assistance with your issue. I own a PC with these specifications: Asrock B550m Pro4 (BIOS v 2.50), AMD Ryzen 5 5600G, Corsair Vengeance LPX 16GB DDR4 (2x8GB) at 3200, Crucial P3 SSD 1TB M.2 NVMe PCI Express 3.0, and Nvidia GTX 1050ti. I intended to swap out the dedicated GPU for the CPU's. After downloading DDU, rebooting into safe mode, clearing Nvidia drivers, and then shutting down, I removed the GPU. After connecting a DP cable to MOBO and pressing power, the boot LED lit but the system wouldn<|pad|> to boot at all. When I removed the M.2 slot again, the same happened. I tried plugging in the GPU once more, and it still didn’t work. Any suggestions?
Reply
Reply
W
WOGGIGAME8
03-26-2016, 06:36 AM #1

Hello. Perhaps the community might offer some assistance with your issue. I own a PC with these specifications: Asrock B550m Pro4 (BIOS v 2.50), AMD Ryzen 5 5600G, Corsair Vengeance LPX 16GB DDR4 (2x8GB) at 3200, Crucial P3 SSD 1TB M.2 NVMe PCI Express 3.0, and Nvidia GTX 1050ti. I intended to swap out the dedicated GPU for the CPU's. After downloading DDU, rebooting into safe mode, clearing Nvidia drivers, and then shutting down, I removed the GPU. After connecting a DP cable to MOBO and pressing power, the boot LED lit but the system wouldn<|pad|> to boot at all. When I removed the M.2 slot again, the same happened. I tried plugging in the GPU once more, and it still didn’t work. Any suggestions?

Reply
Reply
S
Shadarck
Junior Member
Find
3
03-26-2016, 03:29 PM
#2
Fixed. Eliminated the OS m.2 unit. Disconnected the CMOS battery and connected the Crear CMOS pins for five seconds. Restarted into BIOS without the m.2 drive. Once the OS was installed, everything worked properly.
Reply
Reply
S
Shadarck
03-26-2016, 03:29 PM #2

Fixed. Eliminated the OS m.2 unit. Disconnected the CMOS battery and connected the Crear CMOS pins for five seconds. Restarted into BIOS without the m.2 drive. Once the OS was installed, everything worked properly.

Reply
Reply