F5F Stay Refreshed Hardware Desktop System fails to power on and debug lights activate.

System fails to power on and debug lights activate.

System fails to power on and debug lights activate.

I
iKegreenS_
Posting Freak
878
04-13-2019, 09:18 PM
#1
I accidentally left my PC running for two weeks because I overlooked a warning while trying to shut it down. Now that I’m back, I finally turned it off, but it won’t power up again. After turning on the motherboard, the CPU debug LED appears first, then the VGA LED for a while, and eventually all lights go off. Most RGB features work, except RAM, which seems disabled in software. The main issue is I can’t see anything on my monitor. I’ve tried various cables and unplugged the GPU, but the same problem persists. Since I’m using a Ryzen 3600, I can’t boot without a GPU. The rest of my system includes a Ryzen 5 3600X, MSI X570-A PRO Corsair Vengeance RGB Pro 16GB, MSI RTX 2070 Super Gaming, and a 650W Power Plan 11. I appreciate any advice you can offer.
I
iKegreenS_
04-13-2019, 09:18 PM #1

I accidentally left my PC running for two weeks because I overlooked a warning while trying to shut it down. Now that I’m back, I finally turned it off, but it won’t power up again. After turning on the motherboard, the CPU debug LED appears first, then the VGA LED for a while, and eventually all lights go off. Most RGB features work, except RAM, which seems disabled in software. The main issue is I can’t see anything on my monitor. I’ve tried various cables and unplugged the GPU, but the same problem persists. Since I’m using a Ryzen 3600, I can’t boot without a GPU. The rest of my system includes a Ryzen 5 3600X, MSI X570-A PRO Corsair Vengeance RGB Pro 16GB, MSI RTX 2070 Super Gaming, and a 650W Power Plan 11. I appreciate any advice you can offer.

E
Exinity
Member
54
04-16-2019, 05:17 PM
#2
Disconnect the CMOS jumpers or take out the CMOS battery for 30 seconds while the device is powered down. Observe whether this changes the outcome.
E
Exinity
04-16-2019, 05:17 PM #2

Disconnect the CMOS jumpers or take out the CMOS battery for 30 seconds while the device is powered down. Observe whether this changes the outcome.