Simple issues with installing RAM modules Asking about basic problems when adding RAM sticks
Simple issues with installing RAM modules Asking about basic problems when adding RAM sticks
Just before Christmas, I asked a RAM question for an old system ( My motherboard is an ASUSTeK SABERTOOTH X58 CPU with an Intel i7 processor at 3.20GHz. The original RAM was three 2GB Kingston PC3-10600 sticks (256M, 64-bit). I recently got three new 6GB DDR3 sticks (1333 MHz) and tried installing them. It didn’t work. Here’s what I did: 1. Removed all external cables. 2. Cleaned the unused RAM slots with compressed air. 3. Placed the new RAM in slots 2, 4, and 6. 4. Reconnected the power cable and a monitor, then restarted. 5. Tried swapping the original slots with the new ones (matching positions). 6. Reinstalled the RAM and waited for it to boot. Despite following these steps, nothing appeared on the screen. I also tried removing the original sticks and replacing them, but the issue persisted. Now I’m unsure if I’m at fault or if the new RAM is faulty. The only sure way to confirm is swapping the sticks with the original ones.
The RAM appears to be in good condition with no visible damage. All connectors on the motherboard seem properly connected. The speed remains consistent across both units. The main distinction between the RAM I received and the one I ordered is that the latter comes as a pre-assembled kit (specifically labeled 6Gb), whereas my original units are not in that format.
The QVL might have changed since when you 1st installed your MoBo. I would try updating your bios. Also here is the guide to configuring ram placement.
I possess the final BIOS version from 2012. Regarding the RAM setup, it seems you were informed you can't proceed with your current configuration. If I understand correctly, you should ideally have three pairs of identical RAM modules to reach six sticks. You currently have three Model A and three Model B units. Therefore, the optimal arrangement would be two pairs (six sticks total), though I’m still unsure about matching them in the correct DIMMs.
The goal was to increase my RAM capacity from 6Gb to 12Gb, which meant relying on the older units. After switching from Windows 7 to Windows 10, the system used more memory and certain functions became slower, prompting me to boost my RAM. In my original message, people mentioned that mixing DDR3 modules wasn’t typically an issue.
Looks like you're feeling stuck. Hope you find something great soon!