s about Pentium G3258 overclocking
s about Pentium G3258 overclocking
As mentioned a year ago, I was destined to receive a Pentium G3258, and I did. I'm pleased to report that with my 2GB Radeon 6870, everything runs smoothly and exceeds my refresh rate. I connected this CPU to a Gigabyte H81M-H motherboard because I learned it could handle overclocking. The BIOS was set to the pre-Pentium mode, allowing me to freely adjust voltage and multiplier. I gradually increased my CPU to 4 GHz at the standard voltage, which proved stable. However, during gaming, I encountered freezing and crashes, prompting me to lower the voltage by +0.04 volts. This adjustment led to a severe crash and required resetting the CMOS, as the motherboard failed to display the splash screen. I’m unsure whether the issue stems from the motherboard, my cooling solution (a stock cooler at 40°C), or the processor’s sensitivity to voltage changes.
As mentioned before, I was destined to receive a Pentium G3258, and I did. I'm pleased to report that with my 2GB Radeon 6870, all my games run smoothly and exceed my refresh rate. I connected this CPU to a Gigabyte H81M-H motherboard because I found out it could handle overclocking. The BIOS version was the pre-Pentium lock, allowing me to freely adjust voltage and multiplier. I gradually increased my CPU to 4 GHz at the standard voltage, which worked well enough. However, during gaming, when my computer would freeze and crash, I had to lower the overclock slightly. I adjusted the voltage by +0.04 volts, which seemed minor but led to a severe crash and forced me to reset the CMOS since the motherboard didn't display the splash screen. I'm unsure whether the issue lies with the motherboard, my cooling setup (a stock cooler at 40°C), or if the processor resists voltage changes. Windows 10?
As I mentioned before, I was set to receive a Pentium G3258, and I did. I’m pleased to report that with my 2GB Radeon 6870, everything runs smoothly and exceeds my refresh rate. I connected the processor to a Gigabyte H81M-H motherboard because I found out it could handle overclocking. The BIOS was in the pre-Pentium mode, allowing me to freely adjust voltage and CPU multiplier. I gradually increased the clock speed to 4 GHz at the default voltage, which worked well enough. However, during gaming, I noticed frequent freezes and crashes, prompting me to lower the overclock slightly. I adjusted the voltage by +0.04 volts, which seemed minor but led to a severe crash and forced a CMOS reset because the motherboard didn’t display the splash screen. I’m wondering if the issue lies with the motherboard, my cooling setup (a stock cooler at 40°C), or if the processor resists higher voltages.
Sean P shared his experience about getting a Pentium G3258 processor. He mentioned using a 2GB Radeon 6870 graphics card and a Gigabyte H81M-H motherboard, which allowed him to overclock the CPU. He noted that the BIOS was set to the pre-Pentium mode, giving him flexibility with voltage and multiplier settings. He gradually increased the processor speed to 4 GHz on the default voltage, though he experienced crashes during intense gaming sessions. Adjusting the voltage by +0.04 volts led to severe issues, requiring a CMOS reset because the motherboard didn't display the splash screen. He questioned whether the problem stemmed from the motherboard, cooling, or the processor's tolerance to higher voltages.
I mentioned a year ago that I would receive a Pentium G3258, and I did. I'm pleased to report that with my 2GB Radeon 6870, everything runs smoothly and exceeds my refresh rate. I connected the processor to a Gigabyte H81M-H motherboard because I found out it could handle overclocking. The BIOS was set to the pre-Pentium mode, allowing me to adjust voltage and CPU multiplier freely. I gradually increased the clock speed to 4 GHz at normal voltage, which worked well enough. However, during gaming, when my computer would freeze or crash, I had to lower the overclock slightly. I adjusted the voltage by +0.04 volts, which seemed minor but caused a severe crash and forced me to reset the CMOS because the motherboard didn't display the splash screen. I'm unsure if the issue lies with the motherboard, my cooling setup (a stock cooler at 40°C), or if the processor resists higher voltages. Windows 10? Windows 8.1 64 bit. Also noticed that while running Valley Benchmark and Intel burn test, the screen would artifact and turn green. I haven't overclocked my graphics card, so I'm planning to increase the GPU voltage slightly. My power supply is an EVGA 400W with a 1x6 and 1x6+2 PCIe connector.
Sean P shared his experience about getting a Pentium G3258 processor, paired with a 2GB Radeon 6870 graphics card. He mentioned running games smoothly and exceeding refresh rates. He used a Gigabyte H81M-H motherboard, which he thought could handle overclocking. He gradually increased the CPU speed to 4 GHz on stock voltage but faced freezing issues during gaming, prompting him to adjust voltage slightly. He also noted problems with the BIOS not showing the splash screen after changing settings. He questioned whether the issue stemmed from the motherboard, cooling, or the processor itself.
Windows 10 was mentioned, along with Windows 8.1 64 bit. He experienced screen artifacts and color changes during benchmarking and an Intel burn test, though he hadn't overclocked his graphics card. He planned to try increasing GPU voltage.
He explained that his power supply unit (EVGA 400W) had limitations and couldn't support overclocking or even basic gaming. He recommended upgrading the PSU.
As I mentioned before a year ago, I ended up getting a Pentium G3258. I'm pleased to report that with my 2GB Radeon 6870, everything runs smoothly and exceeds my refresh rate. I connected the processor to a Gigabyte H81M-H motherboard because I found out it could handle overclocking. I gradually increased the clock speed to 4 GHz at the standard voltage, which worked well enough. During gaming, I noticed freezing and crashes, so I adjusted the voltage slightly—adding +0.04 volts. This change caused a severe crash, forcing me to reset the CMOS because the motherboard didn’t display the splash screen. I’m unsure if it’s the motherboard, my cooling solution (a stock cooler at 40°C), or if the processor resists higher voltages. Windows 10? Windows 8.1 64 bit. While running Valley Benchmark and an Intel burn test, the screen started to flicker and turn green. I haven’t overclocked the graphics card, so I’m considering a small voltage increase for the GPU. My power supply is an EVGA 400W with two PCIe connectors, but it seems unable to support any overclocking or even basic gaming. It’s possible my PSU isn’t up to the task, and I might need a replacement. If that’s true, why did my previous setup with this card and a 25W CPU run on a 300W PSU? My system draws around 330 watts under maximum load.
Sean P shared his experience about getting a Pentium G3258 processor, paired with a 2GB Radeon 6870 graphics card. He mentioned running games smoothly and achieving higher refresh rates. He used a Gigabyte H81M-H motherboard, which he believed could handle overclocking. He noted the BIOS was set to pre-Pentium mode, allowing him to adjust voltage and multiplier settings. He gradually increased his CPU speed to 4 GHz on stock voltage, though sometimes gaming caused crashes requiring voltage adjustments. He also discussed potential issues with cooling and power supply quality affecting performance.