Ryzen 2600 overclocking possible
Ryzen 2600 overclocking possible
Hey, I just got a used 2600 and a new B450 rog strix gaming-f board. I wanted to overclock it and can raise the voltage normally but can't change the multiplier. It's automatically set to 38.50. If I increase it and save and restart, after reboot and when I reach the Windows setting that my 40.00 multiplier is automatically reset to 38.50, I get it to 4.00Ghz with black overclocking, but some people say it's not safe. All auto overclocking features are disabled. Is there a setting I missed? The old owner said it goes up to 4.2ghz without issues.
You should follow these steps:
Disconnect the PC from the power source.
Press the power button for a minimum of 30 seconds.
Use a flat-headed screwdriver to connect the CLR CMOS jumper (touch both pins) for at least 15 seconds.
Reconnect the PC and press the power button to start it.
Press the DEL key repeatedly.
A screen will appear prompting you to press the F1 key, then do so.
Adjust the Optimized Default settings and click OK (located in the EXIT tab).
Save your changes and exit the BIOS.
Re-enter the BIOS via the DEL key, modify any desired settings, save again, and exit.
I attempted to modify it, but it automatically reverts this TPU setting to the default value of 1.
I suggest you follow these steps:
Disconnect the PC from the power source.
Press the power button for a minimum of 30 seconds.
Use a flat-headed screwdriver to connect the CLR CMOS jumper (touch both pins) for at least 15 seconds.
Reconnect the PC and press the power button to start it.
Press the DEL key repeatedly.
A screen should appear prompting you to press the F1 key, then do so.
Adjust the Optimized Default settings and click OK (located in the EXIT tab).
Save your changes and exit the BIOS.
Re-enter the BIOS via the DEL key, modify any desired settings, save again, and exit.