Reworking the CPU can increase performance, but finding ways to unlock multipliers is another challenge.
Reworking the CPU can increase performance, but finding ways to unlock multipliers is another challenge.
I had an overclocked Q6600. I adjusted the FSB and fine-tuned all the voltages (CPU and RAM).
You raise a valid observation. The memory speed depends on the FSB, as most boards use multipliers to let the memory operate at its standard speed across different FSB configurations. (166/233/333/ect).
It would be wise to verify the memory speed using a tool like CPU-Z before and after this change. Your board might not support changing the voltage, so hopefully it works fine.
Heat should be fine. I'm using two delta fans to push air through a custom shroud I built over the main heat sink. It's a big one, and I'm hoping my motherboard can handle it without affecting the chip's performance.
I had an overclocked Q6600. I adjusted the FSB and fine-tuned all the voltages (CPU and RAM).
You raise a valid observation. The memory speed depends on the FSB, and most boards have settings to keep it stable across different FSB levels (166/233/333/ect).
It would be wise to verify the memory speed using tools like CPU-Z before and after this change. Your board might not let you adjust the voltage, so it should work fine.
This is definitely necessary. I followed the same steps. You need to understand your memory timings, clock speed, and voltage settings. I used CPU-Z or a hardware monitor to gather this information...
Don't be shocked when the memory reads 400 in cpuz, that's typical.
Verify it after the update. Because dell employs numerous CPUs but only a limited range of boards, it should handle it adequately.
If the value shifts (above 400 in cpuz), you'll need to check if the BIOS offers memory multiplier settings.
what is the actual speed then? 400mhz will gradually decrease to match the real speed.
I had an overclocked Q6600. I adjusted the FSB and fine-tuned all the voltages (CPU and RAM).
Was it a Dell system with locked BIOS?
I’m the one.
A lot of my previous links are no longer active, but a few are still working.
I wasn’t expecting many helpful answers so soon,
but I don’t really care who gets the best response since I’m just trying to keep the info going.
I’ll have to review my links first and then share, but it should take about 10 hours (this isn’t my full-time job, LOL).
There are numerous pin mode methods for boosting FSB to 1333 on the Q6600, so proceed carefully.
See you tonight.