F5F Stay Refreshed Software PC Gaming Recent reports indicate FPS problems persist in Mafia 3 following the latest patch.

Recent reports indicate FPS problems persist in Mafia 3 following the latest patch.

Recent reports indicate FPS problems persist in Mafia 3 following the latest patch.

_
_NeoBl0X_
Senior Member
635
06-27-2016, 04:19 AM
#1
Everyone is aware that Mafia 3 ran at a maximum of 30 frames per second before the 1.01 update. Even after installing it and enabling unlimited settings, I haven’t seen more than 30 fps, no matter how I adjust the options. I’m playing on a G1 Gaming 1060 with 6GB RAM. I was hoping for a bit better performance... Do you encounter this issue too? Have you found a solution, or are you just holding out for another patch from the developers?
_
_NeoBl0X_
06-27-2016, 04:19 AM #1

Everyone is aware that Mafia 3 ran at a maximum of 30 frames per second before the 1.01 update. Even after installing it and enabling unlimited settings, I haven’t seen more than 30 fps, no matter how I adjust the options. I’m playing on a G1 Gaming 1060 with 6GB RAM. I was hoping for a bit better performance... Do you encounter this issue too? Have you found a solution, or are you just holding out for another patch from the developers?

C
CykaNuggets_
Member
60
06-27-2016, 05:33 AM
#2
Do you have an MSI afterburner or Precision X? Review your GPU utilization, and confirm Vsync is disabled.
C
CykaNuggets_
06-27-2016, 05:33 AM #2

Do you have an MSI afterburner or Precision X? Review your GPU utilization, and confirm Vsync is disabled.

C
Cupcake_Rose
Posting Freak
844
06-27-2016, 10:00 AM
#3
Currently I see 44-80 frames per second with 1080p at the highest 1440p settings. Make sure VSYNC is disabled, as it could limit performance to around 30 fps.
C
Cupcake_Rose
06-27-2016, 10:00 AM #3

Currently I see 44-80 frames per second with 1080p at the highest 1440p settings. Make sure VSYNC is disabled, as it could limit performance to around 30 fps.

J
jjsoini
Posting Freak
809
06-28-2016, 11:42 PM
#4
Still waiting to fix and test it. I'll check back later once it's done ;O
J
jjsoini
06-28-2016, 11:42 PM #4

Still waiting to fix and test it. I'll check back later once it's done ;O

I
iNaseer502
Member
152
06-29-2016, 01:40 AM
#5
These match the typical results you can anticipate. http://www.guru3d.com/articles_pages/maf...iew,6.html
I
iNaseer502
06-29-2016, 01:40 AM #5

These match the typical results you can anticipate. http://www.guru3d.com/articles_pages/maf...iew,6.html