F5F Stay Refreshed Hardware Desktop Ram operating at 2800Mhz. XMP adjustment not applying.

Ram operating at 2800Mhz. XMP adjustment not applying.

Ram operating at 2800Mhz. XMP adjustment not applying.

B
BetaWolf
Junior Member
Find
37
12-22-2018, 07:35 AM
#1
I'm using a Ryzen 7 2700 with 3.2GHz and an Asus B450M-A board. Each slot has a Gskill Ripjaws 3600Mhz RAM at 1.35V. All slots are active on the motherboard. Frequency stays under 2800Mhz, but it worked at 3200Mhz with just two slots. Enabling XMP profiles always results in safe boot mode. Current BIOS version: 3211 (latest). RAM latency typically ranges from 18 to 22 nanoseconds at 1.35V.
Reply
Reply
B
BetaWolf
12-22-2018, 07:35 AM #1

I'm using a Ryzen 7 2700 with 3.2GHz and an Asus B450M-A board. Each slot has a Gskill Ripjaws 3600Mhz RAM at 1.35V. All slots are active on the motherboard. Frequency stays under 2800Mhz, but it worked at 3200Mhz with just two slots. Enabling XMP profiles always results in safe boot mode. Current BIOS version: 3211 (latest). RAM latency typically ranges from 18 to 22 nanoseconds at 1.35V.

Reply
Reply
S
Sebluigi
Senior Member
Find
727
12-22-2018, 02:36 PM
#2
Did you verify that the additional two units match the original timing? I remember it's common to encounter such issues with older Ryzen models, as they tend to be quite selective about memory configuration compared to the 3000 series.
Reply
Reply
S
Sebluigi
12-22-2018, 02:36 PM #2

Did you verify that the additional two units match the original timing? I remember it's common to encounter such issues with older Ryzen models, as they tend to be quite selective about memory configuration compared to the 3000 series.

Reply
Reply
S
stroudy140
Junior Member
Find
10
12-23-2018, 10:00 PM
#3
Hello! Thank you for your message. Yes, the timing of all the modules is identical. The issue seems to be that the wired setup worked initially but later caused a BSOD. I’m not sure what’s happening.
Reply
Reply
S
stroudy140
12-23-2018, 10:00 PM #3

Hello! Thank you for your message. Yes, the timing of all the modules is identical. The issue seems to be that the wired setup worked initially but later caused a BSOD. I’m not sure what’s happening.

Reply
Reply
N
NateNoah321
Member
Find
57
12-28-2018, 12:46 PM
#4
Most individuals realize only after they look into it That Your CPU Can't Reach 3200MHZ When Using RAM Overclocks
Reply
Reply
N
NateNoah321
12-28-2018, 12:46 PM #4

Most individuals realize only after they look into it That Your CPU Can't Reach 3200MHZ When Using RAM Overclocks

Reply
Reply
B
b_swaggie13
Junior Member
Find
2
01-09-2019, 06:28 PM
#5
It's typical that four sticks slow down more when going faster, particularly on the B450. A better option would be replacing them with two higher-capacity modules.
Reply
Reply
B
b_swaggie13
01-09-2019, 06:28 PM #5

It's typical that four sticks slow down more when going faster, particularly on the B450. A better option would be replacing them with two higher-capacity modules.

Reply
Reply