F5F Stay Refreshed Software Operating Systems Problems following the cloning process

Problems following the cloning process

Problems following the cloning process

G
Gabester12
Member
Find
229
04-06-2016, 11:54 PM
#1
Hello! I'm working on cloning an old SSD to a new NVMe drive and running into problems. When I use Macrium Reflect or AOMEI BackupPer, I see the error messages you mentioned. The old drive uses an MBR format, and after trying to switch it to MBR before cloning, the process failed. I need a solution so I can safely transfer my important files and software.
Reply
Reply
G
Gabester12
04-06-2016, 11:54 PM #1

Hello! I'm working on cloning an old SSD to a new NVMe drive and running into problems. When I use Macrium Reflect or AOMEI BackupPer, I see the error messages you mentioned. The old drive uses an MBR format, and after trying to switch it to MBR before cloning, the process failed. I need a solution so I can safely transfer my important files and software.

Reply
Reply
D
DylanJ145
Member
Find
82
04-11-2016, 12:51 PM
#2
Your bios seems mixed up about the EFI location. Try manual boot by picking the correct boot file and see if it works. After that, run sfc /scannow—it should fix the issue. If not, consider using a rescue and repair bootloader.
Reply
Reply
D
DylanJ145
04-11-2016, 12:51 PM #2

Your bios seems mixed up about the EFI location. Try manual boot by picking the correct boot file and see if it works. After that, run sfc /scannow—it should fix the issue. If not, consider using a rescue and repair bootloader.

Reply
Reply