No response from the PC following the RAM installation and overclocking attempt.
No response from the PC following the RAM installation and overclocking attempt.
Gather the battery and perform the jumper operation too. If this doesn’t fix the problem, then the motherboard is likely damaged. Unless you adjusted your RAM voltage settings, this should be improbable. We’ll address one issue at a time: remove the CMOS battery, switch the jumper to the “clear” configuration, wait 10 minutes, reinstall the jumper, put the CMOS battery back in its correct place, insert just one stick of RAM, and observe the outcome. Provide your update.
Sure, I understand. Let me clarify what you should do next. The blue top-right jumper connects to the jumpers, and the battery is located below that area. You moved the right blue two-pin jumper down one position during CMOS, but you're unsure if that was correct. Please confirm the placement so we can proceed accurately. Thank you for your patience and for following my advice.