Need two routers for a space of 53 square meters.
Need two routers for a space of 53 square meters.
Hi there, I understand your situation. You're living in a concrete apartment building and using a TpLink AX55 for Wi-Fi. The setup seems fine in most areas, but the signal drops significantly in your kitchen, which is only 6 meters away from the router. The distance to the nearest spot is about 44 meters according to Wi-Fi analyzer, with weak reception. You mentioned you've disabled Wi-Fi on the router and used Cat6e cables, but the issue persists. You're considering whether a second router is necessary or if switching to another AP would work without major changes. Since you're not very familiar with networking, I'm curious—does it really take that simple to fix this, or would it be more complex?
You can install a Wi-Fi extender in this way: I own an apartment that's 13 meters long, with an ISP router at one end in the living room. I placed the extender five meters away in the corridor, which helps extend the signal to the other side of the house.
I did this when I lived in an apartment 10 years ago. I placed the router in my bedroom at one end, then used a very thin Ethernet cable to the living room and connected it to another identical router, setting it to AP mode. https://www.monoprice.com/product?p_id=13518 I experienced no problems switching between routers. If you prefer not to run cables between rooms, you should get a newer model that supports mesh networking, which handles connections wirelessly instead.
Hey there! I faced a similar issue while setting up my network at my parents' old brick house built in 1865. The challenge was sending Wi-Fi through 80cm of thick brick—definitely a test of patience. They didn’t want me to run Ethernet everywhere, so I opted for a mesh system and placed nodes on the first and second floors near the doorways. It really worked smoothly!
Thank you for your message. You mentioned having cable already, with the second AP in place, so there shouldn't be an issue. Did the switch happen automatically, or do you need to adjust the network manually? I recall hearing some problems when there are two routers and one still has a weak signal; the device wouldn't switch to the stronger one. Are there any factors you should keep in mind? Appreciate your patience and help!
Connect the cable to the Ethernet extender or coupler for a central location, power up his Wi-Fi, and locate the optimal spot for your AX55 to ensure strong coverage throughout the apartment.
Sure, you don't need a full TP-Link router for AP mode. Just get an AP and run some cable to the other side of the wall, place it there, and use the same name and password. They'll sync automatically. Also, make sure they're on different channels.