F5F Stay Refreshed Power Users Overclocking Need assistance quickly! New RAM overclocking problems.

Need assistance quickly! New RAM overclocking problems.

Need assistance quickly! New RAM overclocking problems.

C
CrimsonNacho
Member
Find
208
07-20-2023, 01:32 AM
#1
my board is an asus prime b450m csm, and i recently added two 16gb ram sticks corsair vengeance pro rgb at 3200mhz. it doesn’t boot from xmp at that speed, but when i keep the speed at 2133mhz or set to 3000mhz, it boots properly. the ram i was using before worked fine without any problems. i tried corsair dominator platinum at 3400mhz and overclocked it to 3200mhz without issues. someone please help me. also, from the ram man site, it says samsung, but i’m not sure if it’s samsung b-die or something else.
Reply
Reply
C
CrimsonNacho
07-20-2023, 01:32 AM #1

my board is an asus prime b450m csm, and i recently added two 16gb ram sticks corsair vengeance pro rgb at 3200mhz. it doesn’t boot from xmp at that speed, but when i keep the speed at 2133mhz or set to 3000mhz, it boots properly. the ram i was using before worked fine without any problems. i tried corsair dominator platinum at 3400mhz and overclocked it to 3200mhz without issues. someone please help me. also, from the ram man site, it says samsung, but i’m not sure if it’s samsung b-die or something else.

Reply
Reply
L
loltribo
Posting Freak
Find
870
07-24-2023, 02:40 AM
#2
Did you purchase these new RAM units as a set or individually?
Reply
Reply
L
loltribo
07-24-2023, 02:40 AM #2

Did you purchase these new RAM units as a set or individually?

Reply
Reply
O
Okunino
Posting Freak
Find
845
07-24-2023, 08:31 AM
#3
as a kit
Reply
Reply
O
Okunino
07-24-2023, 08:31 AM #3

as a kit

Reply
Reply
R
ryangreiner
Junior Member
Find
41
07-25-2023, 11:36 AM
#4
Attempting to clear Cmos can sometimes retain data from previous chips. If that didn't work, consider slightly raising the Dram voltage by 0.1-0.2V. What is your SOC voltage? You might need to adjust it as well. I've used a GSKILL 3000 at 3200 with 1.1vsoc settings. You could test replacing the modules one by one to check for improvements.
Reply
Reply
R
ryangreiner
07-25-2023, 11:36 AM #4

Attempting to clear Cmos can sometimes retain data from previous chips. If that didn't work, consider slightly raising the Dram voltage by 0.1-0.2V. What is your SOC voltage? You might need to adjust it as well. I've used a GSKILL 3000 at 3200 with 1.1vsoc settings. You could test replacing the modules one by one to check for improvements.

Reply
Reply