F5F Stay Refreshed Hardware Desktop Monthly SSD issues on Ryzen 7600 – Mobo, PSU, or SSD changes, newest BIOS, no solution – Assistance needed!

Monthly SSD issues on Ryzen 7600 – Mobo, PSU, or SSD changes, newest BIOS, no solution – Assistance needed!

Monthly SSD issues on Ryzen 7600 – Mobo, PSU, or SSD changes, newest BIOS, no solution – Assistance needed!

D
DDotty2
Member
223
10-13-2023, 10:14 AM
#1
Hello everyone, I’ve been dealing with a long-standing SSD corruption problem on my build for more than a year and feel stuck. Below is a detailed account of the events:

Setup: I’m running a Ryzen 5 7600 with an ASRock B650M Pro RS (BIOS 3.30), a 7900 XT graphics card, an ADATA XPG Core Reactor II 850W power supply, and a 32GB Kingston Fury Renegade 6000MHz DDR5 RAM. The system boots into Windows 11 Pro 24H2 [10.0 Build 26100].

Timeline: Initial Issue: Roughly a year ago, my system began behaving oddly. I opened Event Viewer and saw numerous bad block errors (Event ID 7). I assumed the SSD was failing, so I used CrystalDiskInfo—surprisingly, it reported 100% health.

First Motherboard Change: After some research, I changed the motherboard from the B650M-HDV/M.2 to the B650M Pro RS and performed a clean installation, hoping this would fix things. About three weeks later, a few bad block errors appeared, slowly climbing to around 300 within a couple of days, making the system unusable.

SSD Replacement: Believing it was the SSD, I swapped in my old ADATA SU650 SATA drive and did another clean install. A month passed, and the same cycle repeated: clean Event Viewer for weeks, then a few errors, then a spike to 300, again locking out the system.

Power Supply Swap: Thinking it was the PSU, I replaced my GP-UD850GM with an ADATA XPG Core Reactor II 850W PSU and ran another clean install. Unfortunately, after a month, the corruption returned with the same pattern.

Continuous Effort: This has persisted for over a year, forcing me to perform a clean install every month. The problem remains consistent across all hardware changes.

Troubleshooting Attempts: I updated both motherboards to the latest BIOS versions (currently 3.30). I tried various BIOS configurations—disabling Memory Context Restore, turning off Power Down Enable, adjusting C-state settings, and reverting to defaults. I ran all available stress tests (Prime95 6-hour blend, MemTest64 twice with 4 cycles each, XMP enabled/disabled, PBO on/off), and the system performed flawlessly under load for extended periods without issues.

Windows Power Options: I tested every power setting in high performance mode. For the M.2 drive, I swapped slots and tried with and without a UPS. I ran chkdsk C: /f /r /x, but it didn’t stop the corruption even after completion.

CrystalDiskInfo Insight: The SSD consistently reports 100% health with only 1.17% wear (36TB written).

Current Situation: The corruption cycle repeats monthly during idle usage—starting with a few bad block errors that escalate to over 300 in a day, necessitating a clean install.

What I’m experiencing: The problem appears only when the system is idle, not under load, and it remains consistent across all hardware modifications.

Advice Needed: Could this be related to a motherboard chipset or driver issue? Any suggestions for further diagnostics or similar cases would be invaluable!
D
DDotty2
10-13-2023, 10:14 AM #1

Hello everyone, I’ve been dealing with a long-standing SSD corruption problem on my build for more than a year and feel stuck. Below is a detailed account of the events:

Setup: I’m running a Ryzen 5 7600 with an ASRock B650M Pro RS (BIOS 3.30), a 7900 XT graphics card, an ADATA XPG Core Reactor II 850W power supply, and a 32GB Kingston Fury Renegade 6000MHz DDR5 RAM. The system boots into Windows 11 Pro 24H2 [10.0 Build 26100].

Timeline: Initial Issue: Roughly a year ago, my system began behaving oddly. I opened Event Viewer and saw numerous bad block errors (Event ID 7). I assumed the SSD was failing, so I used CrystalDiskInfo—surprisingly, it reported 100% health.

First Motherboard Change: After some research, I changed the motherboard from the B650M-HDV/M.2 to the B650M Pro RS and performed a clean installation, hoping this would fix things. About three weeks later, a few bad block errors appeared, slowly climbing to around 300 within a couple of days, making the system unusable.

SSD Replacement: Believing it was the SSD, I swapped in my old ADATA SU650 SATA drive and did another clean install. A month passed, and the same cycle repeated: clean Event Viewer for weeks, then a few errors, then a spike to 300, again locking out the system.

Power Supply Swap: Thinking it was the PSU, I replaced my GP-UD850GM with an ADATA XPG Core Reactor II 850W PSU and ran another clean install. Unfortunately, after a month, the corruption returned with the same pattern.

Continuous Effort: This has persisted for over a year, forcing me to perform a clean install every month. The problem remains consistent across all hardware changes.

Troubleshooting Attempts: I updated both motherboards to the latest BIOS versions (currently 3.30). I tried various BIOS configurations—disabling Memory Context Restore, turning off Power Down Enable, adjusting C-state settings, and reverting to defaults. I ran all available stress tests (Prime95 6-hour blend, MemTest64 twice with 4 cycles each, XMP enabled/disabled, PBO on/off), and the system performed flawlessly under load for extended periods without issues.

Windows Power Options: I tested every power setting in high performance mode. For the M.2 drive, I swapped slots and tried with and without a UPS. I ran chkdsk C: /f /r /x, but it didn’t stop the corruption even after completion.

CrystalDiskInfo Insight: The SSD consistently reports 100% health with only 1.17% wear (36TB written).

Current Situation: The corruption cycle repeats monthly during idle usage—starting with a few bad block errors that escalate to over 300 in a day, necessitating a clean install.

What I’m experiencing: The problem appears only when the system is idle, not under load, and it remains consistent across all hardware modifications.

Advice Needed: Could this be related to a motherboard chipset or driver issue? Any suggestions for further diagnostics or similar cases would be invaluable!

C
coolhorse321
Junior Member
3
10-13-2023, 12:58 PM
#2
Through all the elimination steps, the only possible cause is a problem with the CPU's I/O. You've already replaced the motherboard and power supply.
C
coolhorse321
10-13-2023, 12:58 PM #2

Through all the elimination steps, the only possible cause is a problem with the CPU's I/O. You've already replaced the motherboard and power supply.

I
iiFlux
Member
60
10-13-2023, 08:51 PM
#3
The simplest method to determine if the problem stems from memory or SSD issues is to turn off Expo and set RAM to auto in auto mode. The same applies to PBO M and Curve Optimizer. Check if the issue continues.
I
iiFlux
10-13-2023, 08:51 PM #3

The simplest method to determine if the problem stems from memory or SSD issues is to turn off Expo and set RAM to auto in auto mode. The same applies to PBO M and Curve Optimizer. Check if the issue continues.

A
Astro_GER
Junior Member
22
10-20-2023, 06:19 PM
#4
The problem is unclear; symptoms not specified. Updated October 13, 2025 by leclod
A
Astro_GER
10-20-2023, 06:19 PM #4

The problem is unclear; symptoms not specified. Updated October 13, 2025 by leclod

U
UnRuliness
Junior Member
42
10-21-2023, 12:14 AM
#5
I tested the system without XMP and PBO, sticking to default settings. Despite this, it still failed after about a month. Considering an RMA for the CPU seems reasonable since warranty coverage remains. I’ve faced ongoing SSD issues for over a year—Windows records hundreds of bad block errors (Event ID 7) every few weeks, eventually making the system unusable and requiring a full reinstall. The problem keeps occurring across various SSDs, motherboards, and power supplies, with all hardware stress tests passing and drives reporting perfect health. It only appears during idle operation, pointing toward a potential chipset, firmware, or driver issue rather than damaged hardware.
U
UnRuliness
10-21-2023, 12:14 AM #5

I tested the system without XMP and PBO, sticking to default settings. Despite this, it still failed after about a month. Considering an RMA for the CPU seems reasonable since warranty coverage remains. I’ve faced ongoing SSD issues for over a year—Windows records hundreds of bad block errors (Event ID 7) every few weeks, eventually making the system unusable and requiring a full reinstall. The problem keeps occurring across various SSDs, motherboards, and power supplies, with all hardware stress tests passing and drives reporting perfect health. It only appears during idle operation, pointing toward a potential chipset, firmware, or driver issue rather than damaged hardware.

W
WereWolf87
Member
74
10-21-2023, 03:25 AM
#6
I might consider a different SSD. I haven't noticed this problem being caused by the CPU unless it's memory-related.
W
WereWolf87
10-21-2023, 03:25 AM #6

I might consider a different SSD. I haven't noticed this problem being caused by the CPU unless it's memory-related.

E
explizip
Member
227
10-28-2023, 08:56 AM
#7
He switched to a different SSD. Almost everything that might lead to the issue was replaced, save the CPU. That part remains the only remaining possibility.
E
explizip
10-28-2023, 08:56 AM #7

He switched to a different SSD. Almost everything that might lead to the issue was replaced, save the CPU. That part remains the only remaining possibility.

X
X_FredBear_X
Member
226
10-28-2023, 09:19 AM
#8
X
X_FredBear_X
10-28-2023, 09:19 AM #8

T
Treplex
Member
133
10-28-2023, 04:15 PM
#9
It occurred when PBO was disabled and both boards used their standard configurations. Ran Memtest86 and it successfully completed 4 cycles with XMP support.
T
Treplex
10-28-2023, 04:15 PM #9

It occurred when PBO was disabled and both boards used their standard configurations. Ran Memtest86 and it successfully completed 4 cycles with XMP support.