F5F Stay Refreshed Hardware Desktop Maybe a simple recall question?

Maybe a simple recall question?

Maybe a simple recall question?

N
noaskills_69
Member
Find
60
10-17-2016, 11:34 AM
#1
I assembled a contemporary AMD Ryzen 5 5600G setup with a Deskmeet x300 ITX unit. Added an XPG 2x8GB DDR4 3200Mhz memory module. Performance is stable, all components are functioning well. The BIOS shows the RAM speed as 2666Mhz under "Auto" settings, though it offers a manual adjustment option. It seems the 3200Mhz figure likely reflects XMP/DOCP configurations—check if that's correct.
Reply
Reply
N
noaskills_69
10-17-2016, 11:34 AM #1

I assembled a contemporary AMD Ryzen 5 5600G setup with a Deskmeet x300 ITX unit. Added an XPG 2x8GB DDR4 3200Mhz memory module. Performance is stable, all components are functioning well. The BIOS shows the RAM speed as 2666Mhz under "Auto" settings, though it offers a manual adjustment option. It seems the 3200Mhz figure likely reflects XMP/DOCP configurations—check if that's correct.

Reply
Reply
R
RigbyPT
Member
Find
99
10-19-2016, 03:05 AM
#2
Yes.
Reply
Reply
R
RigbyPT
10-19-2016, 03:05 AM #2

Yes.

Reply
Reply
A
astro73
Junior Member
Find
19
10-19-2016, 04:59 AM
#3
You should verify if your system supports a RAM speed of 3200 MHz. Check your motherboard documentation or BIOS settings to confirm compatibility before making changes.
Reply
Reply
A
astro73
10-19-2016, 04:59 AM #3

You should verify if your system supports a RAM speed of 3200 MHz. Check your motherboard documentation or BIOS settings to confirm compatibility before making changes.

Reply
Reply
I
Ion23
Member
Find
170
10-19-2016, 09:52 AM
#4
Ensure XMP is turned on or adjust the DRAM voltage to the manufacturer’s specified value (usually around 1.35V). Set the timings according to the kit’s recommended values (tCL, tRCD, tRP, tRAS) found on the packaging. If you activate XMP correctly, no further changes are needed—just configure it to profile 1 and test with CPU-Z.
Reply
Reply
I
Ion23
10-19-2016, 09:52 AM #4

Ensure XMP is turned on or adjust the DRAM voltage to the manufacturer’s specified value (usually around 1.35V). Set the timings according to the kit’s recommended values (tCL, tRCD, tRP, tRAS) found on the packaging. If you activate XMP correctly, no further changes are needed—just configure it to profile 1 and test with CPU-Z.

Reply
Reply