Legacy Cisco/Linksys E2000 models
Legacy Cisco/Linksys E2000 models
Recently, I settled into a new home. It used to be my grandma's place, so I had to enter and install fresh Cat6 wiring throughout the house. My ISP’s router is performing poorly in many areas, so I was considering setting up a WAP in my room without purchasing a new device. I found an old one I bought eight years ago. Its performance metrics still seem strong (I acquired it before gaining much technical knowledge). I used it for roughly a year and then stored it for seven years, keeping it in its original packaging inside a rubbermaid container, left untouched. As noted in the title, it’s a Cisco/Linksys E2000 Advanced Wireless-N Router. It supports both 2.4 and 5GHz bands, has four gigabit LAN ports (though I don’t intend to use them). My network extends from the ISP’s all-in-one unit to a Netgear 8-port gigabit switch (since the original only offers four Ethernet ports, two occupied by the cable box and another for a separate wireless transmitter). I’m attempting to launch the setup program, but it fails to recognize the router. After running the cables, I’ve connected two outlets in my room, both confirmed functional with my laptop, and tested various cables—consistent results across all ports. Cisco’s FAQ suggests using the reset button, which I did. They also advise disabling your firewall before retrying, which I tried but it didn’t help. Could it be that routing the signal through the switch first and then attempting to connect to the router is causing the issue?
Have you checked the main router’s login and verified the assigned IP? Try pinging or visiting the manual setup page using that IP in a browser. It’s possible the setup software is searching for the default gateway (192.168.1.1), which belongs to your ISP, but it’s being redirected to the Linksys device instead.
Well, the dancing pixies emerging from the wall appear to have adjusted themselves. I experimented with it again this morning for roughly four hours and eventually unplugged it for a reason. After an hour, I plugged it back in and it’s functioning now. Who knows what happened? I hadn’t considered it before, but it seems my laptop isn’t compatible with the 5GHz bandwidth (Intel Centrino Wireless-N 2200, 802.11 b/g/n). I adjusted the settings, and the router vanished from my list of available connections. Still, my phone remains connected. As mentioned earlier, I’m using a wired connection at home. Thanks for your assistance.