Keep the CPU loose and the motherboard without screws overnight.
Keep the CPU loose and the motherboard without screws overnight.
It’s generally safe to leave your unmounted CPU and unscrewed motherboard overnight if you want to avoid dust. Just make sure it’s stored properly and the components are secure. Since you haven’t tightened everything yet, you might want to re-tighten the screws before using it again. The slight warp on the right side could worsen if left undisturbed, especially if the motherboard isn’t fully secured. It’s best to ensure it’s stable and not exposed to vibrations.
lower the ILM arm, make sure its on the board. If its laying flat, you pretty much dont have anything to worry about unless you have a curious cat, then since you are betting the cat wont touch it, the cat 100% will touch it and knock it off the table, then meow at you for not feeding it within 2 minutes of its presence.
It's understandable, but I'm certain it would have been quicker to insert a few screws and lower the arm instead of doing it another way.
I didn’t want to keep applying the solder again because I already repositioned it twice, but I think I can try. As for the CPU, you should be able to leave it in that way.
Are you asking about lowering the ILM and installing the CPU? I didn't intend to do that because it's not advised to force the CPU into the socket without proper support from the standoffs.
It requires a significant effort to take out the solder. I'm not suggesting reducing the screws, only enough to offer the motherboard stability. Will this setup remain functional?
Most PC builders who fit the CPU first before adding the case end up with a problem.