Jbat1
Jbat1
Hi, I resolved the problem using a jumper cable. Alhamdulillah. My monitor wouldn't sync, keyboard and mouse didn't turn on when booting, and all EZ bug LEDs on the MSI board were off. I turned it off, removed the power cable, and pressed the power button to make sure it was fully drained. Then I used a jumper cap and gently pressed down on the right two pins—it felt like the cap was going down. I left it there for 5-10 seconds. After taking it out, it powered on and the LEDs stayed flashing as if checking each part. It entered BIOS CMOS boot mode and then started up. F1 then launched startup. Hope this helps someone else. MSI boards have four pins that connect through me, but I used the correct ones. A note: the black cable to the right of the screwdriver seems a bit loose, but that might just be my perception.