F5F Stay Refreshed Hardware Desktop Issue with pin positioning in the 3.2 gen 1 connector

Issue with pin positioning in the 3.2 gen 1 connector

Issue with pin positioning in the 3.2 gen 1 connector

P
pickle1405
Junior Member
Find
10
06-15-2016, 10:58 PM
#1
Afternoon All, Just into my first build and having a little issue plugging my 2nd 3.2 gen 1 connector into the MOBO. I think I've knocked one of the lower MOBO pins out of alignment and it's struggling to mate. Before doing anything rash and making things worse, was wondering if there's an easy way to get them all in alignment again? The MOBO is now attached to the case and not overly keen on taking it back out.......However, it's a real pain the ass getting good access to it. Any hints, tips or tricks much appreciated. Cheers,
Reply
Reply
P
pickle1405
06-15-2016, 10:58 PM #1

Afternoon All, Just into my first build and having a little issue plugging my 2nd 3.2 gen 1 connector into the MOBO. I think I've knocked one of the lower MOBO pins out of alignment and it's struggling to mate. Before doing anything rash and making things worse, was wondering if there's an easy way to get them all in alignment again? The MOBO is now attached to the case and not overly keen on taking it back out.......However, it's a real pain the ass getting good access to it. Any hints, tips or tricks much appreciated. Cheers,

Reply
Reply