Issue with DIMM slots A1 and B1.

F5F Stay Refreshed Hardware Desktop Issue with DIMM slots A1 and B1.

Pages (2): Previous 1 2

kiddswagg_760
Member

211

07-01-2023, 03:30 AM

#11

I'll test it out. My RAM is managed by my PC technician. I'll check again after a week.

kiddswagg_760

07-01-2023, 03:30 AM #11

I'll test it out. My RAM is managed by my PC technician. I'll check again after a week.

Aurorax_
Member

07-01-2023, 12:07 PM

#12

You could point it out to your tech team to verify the issue, which may help resolve it faster (if that's the fix).

Aurorax_

07-01-2023, 12:07 PM #12

You could point it out to your tech team to verify the issue, which may help resolve it faster (if that's the fix).

AzoTax
Member

209

07-01-2023, 01:20 PM

#13

Yes, this can occur. Earlier DDR4/Intel setups handled errors better, but AM5 appears to require you to use A2/B2 and might fail to boot in the other channel. This isn't advised for DDR5.

AzoTax

07-01-2023, 01:20 PM #13

Yes, this can occur. Earlier DDR4/Intel setups handled errors better, but AM5 appears to require you to use A2/B2 and might fail to boot in the other channel. This isn't advised for DDR5.

SnoopMKWii
Junior Member

07-05-2023, 01:23 PM

#14

It seems the concern is about system stability when using limited RAM configurations. The main worry is that your motherboard might boot in some scenarios with only A1 and B1 slots, but it could become much more sensitive to the RAM modules you choose. You might need to adjust speeds or latency settings to make it work reliably.

SnoopMKWii

07-05-2023, 01:23 PM #14

George2564
Junior Member

07-05-2023, 02:29 PM

#15

If you require additional memory, opt for a 2 stick configuration offering greater capacity. Using four sticks would necessitate lowering the frequency to 5200Mhz or 4800Mhz. Avoid attempting four sticks on AM5.

George2564

07-05-2023, 02:29 PM #15

hdoor20
Senior Member

477

07-11-2023, 10:22 AM

#16

No, your IMC is showing A2 B2 values, A1 is linked with a2 yet you experience signal losses.

hdoor20

07-11-2023, 10:22 AM #16

No, your IMC is showing A2 B2 values, A1 is linked with a2 yet you experience signal losses.

Pages (2): Previous 1 2