Issue with 3200MHz RAM malfunctioning at that frequency.
Issue with 3200MHz RAM malfunctioning at that frequency.
Your setup has a Ryzen 7 2700X, an Asrock steel motherboard, an MSI Evoke OC rx 5700 XT, and 32GB GSKILL Trident Z RGB RAM (two 2x8GB modules at 3200MHz). When you increase the RAM speed past the default 2833MHz, your system crashes and won’t restart until you reset the CMOS. Someone can assist with troubleshooting or configuration adjustments.
You can explore the DRAM calculator for more precise timing details. Setting XMP might require slight adjustments—consider loosening timings slightly or increasing SOC voltage up to 1.2V and DDR4 voltage to 1.5V. Running 4 sticks at higher speeds will be more challenging, though 3200mhz RAM should still work well.
The maximum support memory controller speed is 2933 MHz, but using four dimming units restricts reaching that rate.
It easily handles 3200mhz, mainly using B-die. Otherwise, it just requires more relaxed clock settings.
I'm experiencing XMP issues with my system as well. Since you're just starting with RAM overclocking, are there any simple guides or videos that explain adjusting timing settings safely?
It's not straightforward here. RAM specs aren't simple, and checking XMP settings depends on your motherboard. The BIOS update info isn't clear, and the DRAM calculator might not apply. You mentioned it's been about two years—maybe the hardware is outdated. Consider verifying with the manufacturer or checking online forums.
I increased the voltage and applied the XMP profile. My computer starts up, but once I open Task Manager it reports a RAM speed of 1833MHz. That was my error—I believed it was 2833MHz, but it was actually 1833MHz.
Ensure both kits are using identical memory modules. Sometimes revisions of the same part number occur, and without checking the small labels on each stick, it's hard to confirm they're all the same. Manufacturers may switch suppliers between versions, which could be the cause. However, as previously noted, having more sticks increases the load on the memory controller—though I didn’t lose hope until I verified the revision numbers matched.