Is it advisable to install network cabling on an exterior wall?
Is it advisable to install network cabling on an exterior wall?
It would take approximately 7 minutes outside before it moves into the loft.
Thank you for the feedback on the terms used.
I'll review it carefully.
It's important because the wall hold isn't sufficient for a connector.
I'm curious if I have a correct network faceplate and if the wires can be connected there, then a short wire to the switch would work.
Good thoughts, it's viewable, but I reside in a decent neighborhood. I'll be able to identify if anything is connected to the cable.
Usually a crimp tool and connectors are used once the wire is routed. Applying a crimp to standard Ethernet cable becomes straightforward with the appropriate tools and connectors. For direct burial, more time is needed, but using connectors suited for thicker cables helps. It's worth noting that UV-resistant cable can be used instead, which eliminates the need for certain connectors found in direct burial applications. The key point remains that wiring simply places the wires in, followed by connector installation after placement.
This improves the appearance and adds value through good wiring and wall plates. Swapping the inside cable when necessary is convenient, avoiding excess cables that get tangled or need cutting later. Older homes often have unsightly cables like TV coax outside due to retrofitting, usually done cheaply with poor quality work. A nice covering that lasts longer helps more. Even plastic conduit looks better than exposed cables that are just stapled or hanging.
You can choose faceplates/jacks that don’t need a punchdown tool, though they cost a bit more—better for occasional use. A basic cable tester is recommended for both wall jacks and direct cables. If you’re new to this, mistakes are likely, so double-check the pinouts and connections. Make sure the sheathing is properly crimped in the connector to keep the cable secure, especially if you don’t use wall jacks.