Installation Guide for Hyper 212 Evo
Installation Guide for Hyper 212 Evo
I bought a PC about two weeks ago and assembled it correctly, except for an issue with the aftermarket cooler. When I tried to install everything, one side would slightly pop in while the bracket would lift up, making it hard to push down for the other sides. I switched to the stock cooler now but plan to overclock my FX 8320 soon. Any advice or suggestions would be appreciated?
The X-clip features a screw and notch designed to connect with matching holes and pins on the top of the heatsink's base, ensuring it stays securely in place. If alignment is off, the retention clip may not sit properly and won't allow you to secure the opposite side. When properly aligned, applying force should be manageable without excessive effort. For better results, start with a few turns before fully tightening the screws. The HSF may still move slightly even after tightening, so continue applying pressure gently.
The X-clip features a screw and notch designed to connect with matching holes and pins on the top of the heatsink's base, ensuring it stays securely in place rather than sliding over the CPU. If alignment isn't precise, the retention clip may not sit properly and won't allow you to secure the opposite side. When correctly aligned, applying force should be manageable without excessive effort. For best results, start with a few turns before fully tightening, cycling the screws slightly to ensure even engagement. The HSF may still move slightly even with tightening, so avoid over-tightening. It should be snug enough to remove any slack or wobble, though the exact requirements may vary between models.