Instability in GPU overclocking, reduced frame rates following higher clock speeds
Instability in GPU overclocking, reduced frame rates following higher clock speeds
I'm dealing with a curious issue regarding GPU overclocking on my computer. After purchasing a used GTX 970 to swap in for my older 960, I discovered its impressive overclocking capabilities. However, I remained cautious since most other GPUs I tested on this motherboard (GTX 745, XFX AMD Radeon HD 6850, GTX 960, and now the 970) tended to become unstable, often crashing and delivering lower frame rates than before—even though the display showed no artifacts. The most puzzling part was that when I experimented with overclocking the memory, I noticed a slight improvement in frame rate and could push the overclock further without any crashes or visual issues. But once I increased the GPU clock speed, performance dropped significantly, and frame rates began to decline. I also tried raising the voltage, but it had no effect. This situation seems to point toward a motherboard issue, especially since my system uses a stock Dell board from a XPS 8700 with an i7-4970 and 16 GB of 1600 MHz Hyundai/Hynix RAM. Any advice would be greatly appreciated!
🚫 Avoid pushing the processor beyond its limits!
The system is a single unit not built for overclocking or graphics cards, and the power supply might not have enough capacity.
Don't attempt to run the 970 in it—it could damage your entire PC.
If possible, replace it with a better option like the Corsair CXM 550w (black label).
🚫 Avoid pushing the processor beyond its limits!
The system is a single unit not built for overclocking or graphics cards, and the power supply might not handle the task.
Don't attempt to run the 970; it could damage your entire PC.
If possible, replace it with a better option like the Corsair CXM 550w (black label).
My phone acted strangely and chose that answer as correct, making it hard to deselect. Nonetheless, I should note that I recently swapped out the PSU with a Thermaltake 600w unit. That means it's running at 100 watts above the minimum requirement, and even lower wattage cards had similar issues before.
Certainly. If I purchased a gaming motherboard with identical RAM and CPU slots, I believe I could install the processor and RAM without issues. Please let me know if you'd like further clarification.
It won't work at all right now, he's already avoiding the system. Plus, the motherboard lacks enough power phases for overclocking, the chip isn't built for that, and using a bad PSU will likely cause the system to fail when you try to overclock.