Identify the issue with your PC hardware and seek clarity on the problem
Identify the issue with your PC hardware and seek clarity on the problem
TL;DR – The PC freezes and restarts only after about 15–20 minutes of idle time. I've tried all fixes except hardware removal. I'm seeking advice on which component to inspect first before proceeding with a full disassembly. System specs: Windows 11 Pro (10.0 Build 22000.318), AMD Ryzen 9 7900X, RTX 3080 Ti, DDR5 RAM, and an EVGA 1000 P3 power supply. I'm using a Samsung SSD for installation and storage. The issue happens when booting with the EXPO profile at 6000MHz or stock settings at 4800MHz. No crashes occur under heavy load, only occasional reboots during light tasks like YouTube playback. I've cleaned the system, reinstalled Windows twice, checked error logs, run stress tests, and tested drivers multiple times. The crash code is 141, suggesting a hardware fault. I'm unsure whether to focus on GPU, power supply, or other parts. Suggested next steps: test GPU with iGPU emulation, verify PSU output, and consider BIOS updates. Let me know your thoughts before you start pulling anything."
Thank you for the feedback. I'm looking into using AIDA64 to recreate the problem. How often did you usually perform stress tests before it crashed? Also, would it help if I turned off Global C States in the BIOS?
This seems to point toward memory problems, possibly from software or firmware instability or a faulty hardware setup. Several upcoming BIOS versions focus on stability and memory support, so updating is strongly recommended. The "Beta" label shouldn’t deter you—it should function properly once applied. Newer Ryzen models often face memory stability challenges at launch that need BIOS fixes. I’d start with the latest BIOS update first. If that doesn’t resolve the issues, your RAM is likely the main cause. Testing a different RAM module could be the next step in troubleshooting.
I overlooked mentioning that I attempted to update the BIOS to a beta version, but my system would no longer boot with a C5 error on the MB. I fixed that by going back to version 1.11. While I’m open to trying again, I prefer updating the BIOS only as a final resort. Last time it caused panic when it wouldn’t boot after an update—RAM seems like a likely culprit, especially since it stayed stable under stress but crashed during idle after running Memtest86 with EXPO. I’ll look into replacing the DDR5 kit if I can find one. I’m considering disabling Global C State to test, though. Currently, stress tests in AIDA64 are running smoothly. Thanks for your support!
Just an update, I tried disabling the Global C State in BIOS but still had the same crash. Still stable after the crash and running AIDA64. I'm going to try and pull the ram and then the graphics card to see if I get different results but as always I'm open to any ideas.
I've worked on getting my computer running smoothly again. After three days without any crashes—normally I'd have at least one each day—I realized I'd tried many fixes at once, making it tough to pinpoint the cause. If things stay stable for another four days, I plan to gradually add overclocks and tweak some BIOS settings to narrow down the problem. So far, I updated my BIOS to version 1.11 AS06. Previously, I attempted a flash to 1.11 AS03, but that prevented the system from booting. Since the latest version seems working fine, I disabled Global C States (though it didn’t help before), and adjusted the PSS GPU settings. I propped up my GPU with a makeshift bracket made from a booklet and a 3D-printed rook. In Nvidia Control Panel, I ensured the card ran in high performance mode. I also tried anointing it with oil, burning incense, and singing a hymn—something that worked or combined those methods helped stabilize the system temporarily. I’ll keep testing to confirm the fix and see if others face similar issues.