i7-9700KF Core Vid min/max/average
i7-9700KF Core Vid min/max/average
Hello everyone,
could you please review my outcomes following the overclock? The settings were at 5Ghz.
CPU clock ratio: 50
CPU base clock: Auto
CPU Vcore (bios -1.34V)
Uncore Ratio: Auto
LLC-High
XMP target: 3200Mhz
The results are from after 2 hours of gaming.
https://ibb.co/Lx832N0
My sense is that you are too high.
I see 1.48 max vid.
I also see clocks consistent near 5.0.
If you implement adaptive voltage and speedstep, your multiplier and vcore will drop when there is little to do.
That, I think, would be a good thing.
I do not see any temperature history.
I don't understand what I should do...:-D Where is the adaptive voltage and speedstep? Why do I need lower CPU voltage in max settings? This is just the processor's requirement, but I set 1.30V and Vcore on the motherboard, which is shown in HWInfo: Min:1.272V/Max:1.380/Average:1.348V. VID is connected to clock speed. It's what the CPU expects at a certain speed, unrelated to actual voltage unless your BIOS has everything set to auto. Here are some temperatures: https://ibb.co/s5jcnHs
Motherboard manufacturers use various names for these settings. It's best to visit a Gigabyte overclocking forum for detailed information. In the meantime, reduce your target by a few levels.
My method is straightforward:
Restore everything to auto mode.
Then slowly raise the all-core multiplier and monitor progress.
Once you hit your threshold, decrease at least one multiplier.
Your final setting should stay around 1.35 vcore as recorded by cpu-Z, and not exceed 85°C during a stress test using HWmonitor.
You might not reach the chip's full potential, but it will still be safe and satisfactory.
Not every chip supports 5.0; you could end up with something less impressive.