I7 7700k liquid cooled attains 100c
I7 7700k liquid cooled attains 100c
If you are absolutely certain the CPU waterblock is properly installed... Ensure the thermal paste is applied correctly, verify adequate airflow around the radiator, and confirm the pump is functioning.
If everything checks out, proceed to remove the CPU.
In short, it’s because Intel, from the third generation up to the current one, has been using thermal paste instead of soldering directly between the CPU die and IHS...
I own a 7700k and faced the same issue you mentioned.
I used this tool: https://rockitcool.myshopify.com/
Swap the faulty Intel thermal paste with this one: http://www.thermal-grizzly.com/en/produc...ctonaut-en
Now, if you visit my CPU-Z Validator link in the bottom right corner of this post, you’ll see the current speed and voltage I’m using. You’ll also notice CPU temperatures, which are likely within acceptable limits even under heavy load on all cores.
At full load, I never exceed 62-63°C.
In summary, should I proceed?
Do you want to risk damaging your CPU and replace it?
Are you extremely concerned about temperatures and aiming for the lowest possible values?
Would you consider pushing the CPU to its limits and reducing clock speeds by 50–100MHz for continuous daily use?
If yes, then removing the CPU is definitely the right choice.
I wonder if delaying will solve your issue, did you test the CPU with air first? Deliding might only reach up to 12 degrees at most? Possibly around 20? I own a 7700k and a custom loop at 5.1 is much cooler. If you didn’t run it on air and stock, I suggest doing that. What temperature did it hit during stock speeds/voltage on water? Maybe your chip can’t reach as high as you’re seeing.