I need GPU specialists, I might damage my GPU.

Pages (2): 1 2 Next

Brudora
Senior Member

726

10-06-2018, 05:40 AM

I was attempting to overclock using the VF curve on my Gigabyte WindForce RTX 2070. I adjusted it to the maximum settings at [email protected], and the temperatures look normal with the stock air cooling. I’m unsure if this method will damage the GPU. This seems unusual and I’m not sure what I just did.

Brudora

10-06-2018, 05:40 AM #1

Lyndiegeek156
Junior Member

10-10-2018, 11:09 AM

THEN DONT DO IT

Lyndiegeek156

10-10-2018, 11:09 AM #2

THEN DONT DO IT

905xA
Senior Member

667

10-10-2018, 05:54 PM

Heaven states my frequency is 2700mhz, but that seems impossible since it would mean a +500 difference in core clock.

905xA

10-10-2018, 05:54 PM #3

Heaven states my frequency is 2700mhz, but that seems impossible since it would mean a +500 difference in core clock.

Broflash
Senior Member

740

10-11-2018, 10:56 PM

. . . why?

Broflash

10-11-2018, 10:56 PM #4

. . . why?

ricby
Senior Member

681

10-12-2018, 06:23 AM

It's fine, your GTX660ti is running at +220/+820 above the factory settings. That's correct for a 660ti, not an 1660ti.

ricby

10-12-2018, 06:23 AM #5

It's fine, your GTX660ti is running at +220/+820 above the factory settings. That's correct for a 660ti, not an 1660ti.

NinatoPvP
Posting Freak

899

10-13-2018, 12:13 AM

If you're unsure about over-clocking—anything at all—just don't do it.

NinatoPvP

10-13-2018, 12:13 AM #6

If you're unsure about over-clocking—anything at all—just don't do it.

ChainChompz
Member

187

10-13-2018, 01:29 AM

The 54% increase in the core clock appears too much, especially since it causes him concern.

ChainChompz

10-13-2018, 01:29 AM #7

The 54% increase in the core clock appears too much, especially since it causes him concern.

RigbyPT
Member

10-21-2018, 03:20 AM

I started with +130 core +215 men and stock voltage. Using the VF curve, I adjusted the voltage to 1075. Now GPUz reports a clock under sensor of 2100, while I believe it should be 2350.

RigbyPT

10-21-2018, 03:20 AM #8

I started with +130 core +215 men and stock voltage. Using the VF curve, I adjusted the voltage to 1075. Now GPUz reports a clock under sensor of 2100, while I believe it should be 2350.

ChloeET
Senior Member

736

10-21-2018, 03:37 AM

Is that safe for my card ?

ChloeET

10-21-2018, 03:37 AM #9

Is that safe for my card ?

iTzTraze
Junior Member

10-21-2018, 05:26 AM

#10

Someone can guide you on optimizing your GPU usage to maximize performance while preserving its lifespan.

iTzTraze

10-21-2018, 05:26 AM #10

Someone can guide you on optimizing your GPU usage to maximize performance while preserving its lifespan.

Pages (2): 1 2 Next