I can assist with that. Let me know how you'd like to proceed.
I can assist with that. Let me know how you'd like to proceed.
I have a particular issue I need assistance with. I need to link to one LAN via Ethernet without internet access, and at the same time keep a separate LAN connected to the internet through Wi-Fi on the same machine. I tried bridging the two networks but it didn’t work. For instance, I want to access 192.168.0.10 through a browser while maintaining internet connectivity from 192.168.1.1 over Wi-Fi.
Configure fixed IP addresses for devices linked to the adjacent network card. For instance, assign a static IP of 192.168.0.2 to the second adapter and 192.168.0.10 to the computer on the opposite side.
my wifi adapter is configured to get an ip from dhcp, while my ethernet adapter has a static address of 192.168.0.200. another key point is that i need to find a method to reach the device on the non-internet lan using a browser. chrome seems to treat it as if it's using wifi instead of the ethernet adapter, even though the subnets are correctly set.
dhcp should assign an IP from another subnet than 192.168.0.XXX. Avoid adding gateway or DNS servers to the second interface. If the interfaces have different operating systems, the one in the same subnet as the target IP will be selected. The interface with a gateway and initial response is the one intended for internet access.
It seems you prefer keeping the links separate. If your goal is for your computer to connect across both networks, minimal adjustments should suffice. Still, several typical problems can arise. The networks must not share identical IP ranges. For example, if one uses 192.168.0.x and the other 192.168.1.x, change this across all devices in each network—this affects everyone, not just your PC. Make sure no default gateway is configured on the network without internet access; otherwise, the computer might assume Ethernet is the best route. Name resolution could be confusing. If everything on the Ethernet side runs Windows, NetBOIS should already be active. Without it, you may need to create a local domain and DNS server, which becomes complex fast. Alternatively, using IP addresses instead of names works too. If this doesn’t resolve the issue, share more details about the challenges you’re facing.