How to link a device to a distant computer using an Ethernet connection?
How to link a device to a distant computer using an Ethernet connection?
If the router has Access Point isolation configured, it prevents connections between Wi-Fi and wired devices. Additionally, a remote computer must have remote access activated for remote desktop use, or file sharing must be enabled for accessing shared files.
During the testing phase, there was no wifi connection in use. RDP was enabled, and XRDP was installed on Linux. It's important that the Windows PC's network profile is set to Private, not Public. Could you confirm if everyone could ping each other using their IP addresses?
All previous experiences have been successful. I managed to connect without any issues until now. My consideration for using four cables is whether it's more efficient to pull as many as possible into the conduit initially rather than having to adjust them later.
It would be helpful to include a simple diagram showing all devices and their connections. Please note the previous setup that functioned and identify any changes that caused issues. Posting this to Imgur is recommended.
The wifi was active on the router, but the link to the remote machine from it is weak. That's why Ethernet cables are needed. All configurations on the remote device were (or should have been) configured for remote access. Because the remote computer hasn't been turned on for a while, I doubt any changes occurred. I'm using Remmina on my Linux system.
It's true you tend to use as many wires as possible. In reality, you probably won't need them beyond backup. Running a single cat6a cable capable of 10gbit could suffice, and adding VLANs would provide necessary network separation if needed. Have you considered the straightforward solution of bringing the remote computer into the house with a short connection? Do you have a compact switch? It might function well in the remote area, allowing you to plug the remote into the switch instead. This effectively turns the switch into an Ethernet extender.
I think the problem remains with the cabling, particularly if you're doing it yourself. It would be better to recommend pre-made cables for regular users.
Actually never thought of doing that since there's quite a bit to unplug but that would be the next thing to try.
Got one of those cheap testers. It did catch a previous problem with the short cable run that I had to replace the end.
I'm leaning that way though it's surprising that trying different cables still doesn't fix it. They all can't be bad. I'm going to have to try some more different cables and check the continuity again.