Hey there! What’s going on?
Hey there! What’s going on?
Sure thing, buddy. I gave it a shot with two sticks and four both. It seems like XMP is causing problems—blue screens and crashes when I run it at base frequency. But at higher frequencies it works fine. I’m planning to tweak the timings manually. If you can, could you share a link to a site with the right specs for my RAM and speed? Thanks again!
I've noted the locations you need to check. In the bios, locate the SPD memory profiles. They display the timing details for Jedec and XMP profiles. You should adjust the timings manually rather than relying on auto in the memory settings. Make sure XMP is enabled, enter the right timing values, set the memory frequency multiplier to 3200mhz, apply F10 save, then run a post-test.
I attempted it but couldn't locate it on your motherboard, similar to trying to short the jbat1 pin without success. Could you provide details about your specific M.2 slot and any error messages?
Your exact motherboard is identified. If the jumper isn't present on the board itself, it's probably inside the accessories package included with it.