Guide to Troubleshooting Legacy Hardware on Home Patch Panels
Guide to Troubleshooting Legacy Hardware on Home Patch Panels
I'm really unsure about setting up networking from wall outlets. It sounds like you're trying to connect your router to a panel, possibly using older equipment from the late 90s or early 2000s. Could you share more details about what you have and any specific issues you're facing?
They are CAT 5 or CAT 5e patch panels, connecting various spots inside the house. Your internet enters through your home and depends on whether you have fiber optic or not—there will be a modem or ONT box. The Ethernet exits from that and proceeds to your main router. To give ethernet to all rooms, you’ll need a switch. The router connects to one port on the switch, and cables link the patch panel to the switch. If your router uses 4G LTE or 5G, skip the idea of a house-to-home cable going directly to a modem.
It seems they set up the system for phone lines. The lower patch panel features connections that are daisy chained, and these link to the upper panel for distribution. If the upper panel and keystone jacks in the rooms are properly connected, you should simply detach the patch cables from the lower phone panel and connect them to your network switch ports. A budget-friendly network tester can assist in checking your runs and confirming proper termination. The type of cable affects speed—Cat 5 supports 100MB Ethernet, while Cat5e handles up to 1GB. Ideally, you should use Cat5e or higher.