Discussing ways to boost the performance of an I5 8600k processor
Discussing ways to boost the performance of an I5 8600k processor
I'm working to push my CPU overclock beyond 4.8, but it's not stable. My BIOS says I can go up to 4.7, and currently I'm at 15,860 kHz with a stable 1.28V voltage. Thanks for the help!
There are numerous resources available on how to overclock these processors; you should check them out.
If the CPU isn't stable at the desired multiplier, it indicates you need to raise the Vcore for stability. Adjust it slowly unless your system passes the Intel Burn Test, after which you can verify stability using Prime95 Blend.
Additional detailed instructions and guides are accessible online.
There are numerous resources available on how to overclock these processors; you should check them out.
If the CPU isn't stable at the desired multiplier, it indicates you need to raise the Vcore for stability. Adjust it slowly unless your system passes the Intel Burn Test, after which you can verify stability using Prime95 Blend.
Additional detailed instructions and guides are accessible online.
100C on CPU package during stress testing is problematic; lowering voltage helps if stability returns. If it remains unstable, consider reducing overclocking. I'm running a 3570K that's stable at 4.6 with temperatures under 80mV/√°C below 80°C, but needs above 1.3+ for stability at 4.7. My cooler is an EVGA CLC 280. To push overclocking further, you can either purchase a quality AIO with 280 or 360 RAD, or delide the processor and apply Liquid Metal (this voids warranty).
currently I increased the overclock to 4.5 at 1.23v on 83°C. I'm considering purchasing a reservoir with a pump and a 240 radiator, using the two existing 120 radiators on the close AIO. Since my 1080 is hybrid, I plan to reuse both radiators along with the waterblocks that have the extra pumps inside, so I won't have to spend too much. What do you think? Thanks for the suggestions!
You have two 120mm RAD units—one for the GPU and one for the CPU. For custom liquid cooling, it could significantly lower temperatures; if you can afford it, it’s worth considering.
I’m not very familiar with reusing a closed AIO RAD, as it’s sealed tightly. Using it without the correct brackets for the 120mm RAD might lead to leaks.
It would be better to keep the GPU with the 120 RAD. The issue isn’t with the GPU itself, but you should plan to replace the water block and reservoir for the CPU later. You could buy a new GPU water block and sell your H60.
I will mention this when I purchase the pumps and everything will be completed so you can compare the differences in temperature and appearance. The H60 is an older model, so it has been around for a couple of years, which makes me feel it isn't completely waterproof, so I'm planning to do a custom one.