Discussing ASUS Ethernet backhaul and multiple devices via an unmanaged switch.
Discussing ASUS Ethernet backhaul and multiple devices via an unmanaged switch.
Hello, your recent purchase of Asus XT8s is great! You’ve set up a direct connection between the ISP modem and the first XT8 acting as a router. The WAN plug is linked to a TP-Link unmanaged switch upstairs, while another XT8 is connected to that switch and your camera system DVR. Although the two XT8s work well together, you’re missing your DVR from the list of active devices—only showing a single "Tp-Link" connection. This suggests the switch might not be properly identifying all devices or there could be an issue with the switch’s configuration. To get everything visible and connected, check the switch’s settings to ensure it recognizes all devices, and verify that your DVR is properly assigned to the correct network. Also, confirm that the TP-Link switch can communicate with your ISP modem without interference.
Would you like to connect your main ASUS XT8 to the switch instead of using it as a router? Should I verify the issue by scanning devices with a third-party tool or checking your main modem?
I’m a bit unclear about the setup. The router connects to the modem via the WAN port, and one of its plugs links to the switch. In the ASUS router’s GUI, I see what devices are connected. I also had another Netgear router before, but there was an issue where I couldn’t view the camera system on the house Wi-Fi. Does that help?
If the setup works as a single unit (modem, router, AP), you can remove the ASUS equipment and link the modem straight to the switch. Then check the network to confirm the issue isn't caused by the ASUS gear.
You connected either a WAN port or a LAN port from the Asus device to the switch.
@Awsomestar123456 and @Lurick are correct. Please ensure ASUS is linked to the WAN, then connect the switch via LAN port.
I plan to test this at home and am uncertain if the fiber box functions as a router. The primary connection goes from a LAN to the switch, after which the node links to the WAN through the switch—something I see on the ASUS website for setting up nodes via a wired backhaul.
You need a single cable connecting the main router to the basement. This is typically done using a dedicated trunk port or a splitter to distribute the connection efficiently.
Yes, your notes seem mostly accurate. The cable is likely needed for reliable data transfer, especially over WiFi. Everything you described about connections appears correct based on what you shared.