Did I damage three transistors and is it alright?

javanoob
Junior Member

10-22-2016, 07:32 AM

I was working on my project and decided to use some aluminum in a three-transistor circuit. Should it be fine?

javanoob

10-22-2016, 07:32 AM #1

I was working on my project and decided to use some aluminum in a three-transistor circuit. Should it be fine?

dniznemac
Senior Member

555

10-22-2016, 12:58 PM

Which kind of transistors are you asking about?

dniznemac

10-22-2016, 12:58 PM #2

Which kind of transistors are you asking about?

carraboy31
Member

117

10-23-2016, 07:39 AM

carraboy31

10-23-2016, 07:39 AM #3

taeranghee
Member

148

10-26-2016, 06:56 AM

Upon closer inspection, it's clear there are a few components, possibly a transistor, located near the chip.

taeranghee

10-26-2016, 06:56 AM #4

Upon closer inspection, it's clear there are a few components, possibly a transistor, located near the chip.

Exo_GuNZz
Junior Member

10-26-2016, 03:35 PM

Here are two smaller versions:

1. And two more details below.
2. See these additional points.

Exo_GuNZz

10-26-2016, 03:35 PM #5

Here are two smaller versions:

1. And two more details below.
2. See these additional points.

Anselhero
Senior Member

582

10-26-2016, 05:34 PM

To be sure, you should start it and check. It looks like it should work, though anything could happen.

Anselhero

10-26-2016, 05:34 PM #6

To be sure, you should start it and check. It looks like it should work, though anything could happen.

ThEGaM3r1337
Junior Member

11-14-2016, 01:14 AM

They aren't transistors. Transistors come with three connections. Those could be resistors or capacitors. If they're connected incorrectly, it might cause an issue, but if they're just not touching, it's usually fine.

ThEGaM3r1337

11-14-2016, 01:14 AM #7