CPU pins bent during installation of an AIO ripped CPU unit.
CPU pins bent during installation of an AIO ripped CPU unit.
Hi, during the maintenance I started on the PC, while removing the AIO, it pulled the CPU (5800x) out with it, and the CPU lock was activated. I managed to free it from the AIO, but noticed two pins were bent. I don’t have a magnifying glass or anything flexible that could help bend them back. Is this going to be a tough job? Should I consider replacing the CPU altogether? Also, did I do something incorrect? The CPU seemed stuck inside the AIO—maybe too much force wasn’t enough to move it properly.
For minor bends, a regular .7 mechanical pencil performs adequately (I've used one before). When it comes to removal, it's recommended to apply pressure to warm the adhesive and gently shake it.
Some individuals prefer using a credit card, simply sliding it between the pins often realigns them (though I haven’t succeeded with this approach). I usually use a pair of tweezers to adjust them back, as those in iFixIt kits perform well. Most small sharp objects are effective for this task. You don’t necessarily need a magnifying glass; just inspect along the side and it should be clear if a pin is misplaced when viewed down the rows. It’s a slow process, but manageable. Take some time to relax beforehand—play music, go for a walk, have a drink, whatever helps you stay calm—and be patient; they’ll likely come back together eventually.
It seems like a small issue, perhaps a bit slow, but it should be straightforward to reverse. My approach relies on my nails, though they don’t seem to help much after cutting—using a razor would be better, but I’m too lazy to find the right tool. Handling the CPU with fingernails isn’t ideal.
When examining the pin layout, placing a thin paper, sticky note, or index card behind the area you adjust can ease the strain. This trick worked well for bending pins on an LGA2011-3 server board.
Using a scalpel works for you. Ensure the area is brightly lit. A magnifying glass is extremely useful, and a yellow sticky note helps maintain clear alignment.
I'm a bit older now, so I did it right in front of the lamp, okay? I wouldn't use a scalpel, but I haven't made a model in years. I had a few in a row, which helped with the length.