Considering your card might not be good, but you're unsure.
Considering your card might not be good, but you're unsure.
Build I've been running for years, 5600x, 32gb, rx6650xt on a msi b550. Took it apart for a case swap, can't get it to post. Mobo vga light is on and no signal. Try the second slot, computer does boot but see pics, it slowly morphs. I went and got my old 1060, boots in top slot just fine. Is it my card or something else? I don't see why a worse slot would give me an output if the good one doesn't boot at all and I don't see any damage to the board
Start by testing another monitor cable. If possible, switch to a different monitor as well.
Well, this situation feels like my GPU is failing badly and I’m barely able to function if not just watch it melt away into a mess of tears. Before attempting anything, as @Eigenvektor mentioned, experiment with different cables, monitors, and try connecting it to your TV using the same cable you’re currently using. If you’re using DisplayPort, switch to HDMI and repeat the tests—it could point to a port issue. Consider testing it on another system or even in a friend’s setup to see if the problem persists. If none of these steps help, proceed with caution. This isn’t a fix, but a trial for understanding the issue. If it worsens, don’t hesitate to reach out to your GPU manufacturer’s support and check the warranty. In my experience, the GPU performed okay under normal conditions but crashed under stress or heat, likely due to a damaged solder joint from repeated case swaps or motherboard changes. I tried the suggested method, but it didn’t resolve the problem. It might have worked for me, though—it’s based on personal experience and not guaranteed for everyone. If you’re serious about trying, treat it as a science experiment. Just remember: this isn’t a guaranteed solution, and you should consider your options carefully.
Tried another HDMI cable, nothing worked. Before deciding to dismantle the card, I wonder if a repair shop would check it for me. It might just be a faulty part, but since it boots in an x8 slot (though the back has fewer pins than the other), I’m a bit hopeful it’s not a total failure. The last time I tried reballing was for a 360, which took about six hours and ended in failure again after a month.
I'm likely to reach out next day, as I saw some browsing and xfx mentioned 3-year offers. I purchased in December 2023. If neither works, is there a forum section that values photos of my attempts to reball it? I’d appreciate a stencil this time.
Depending on the situation, it could even be pointless to focus only on the GPU, as a small crack elsewhere might be all that’s needed. If it turns out the issue is just a cracked solder joint somewhere else, the oven might treat your GPU like it’s broken, but if you decide to reball it, I’m really keen on seeing videos and photos—it’s a fascinating process I wanted to understand.